Invacare TDX SI Disconnecting/Connecting the Joysticks, Adjustable Asba Seats, SPJ+ Joysticks

SECTION 5—WHEELCHAIR OPERATION

Adjustable ASBA Seats

NOTE: For this procedure, refer to

FIGURE 5.10.

1.Turn the adjustment lock lever to release the joystick mounting tube from the mounting bracket.

2.Remove the joystick from the wheelchair.

3.Remove the three hex screws that secure both halves of the mounting bracket to the arm tube.

4.Reposition mounting bracket on opposite arm tube ensuring the threaded plate of the mounting bracket is on the inside of the arm tube as shown in FIGURE 5.10.

Mounting	Mounting Bracket
	(Threaded Plate)
Bracket
Washers
	Arm Tube
Adjustment	NOTE:
Lock Lever	Joystick
Hex Mounting	not shown.
Screws	Joystick Mounting Tube

FIGURE 5.10 Repositioning Joystick -

Adjustable ASBA Seats

5.Using the three hex mounting screws and washers, secure both halves of the mounting bracket to the arm tube.

6.Slide the joystick mounting tube through the mounting bracket to the desired position.

7.Turn the adjustment lock lever to secure the joystick mounting tube into the mounting bracket.

Disconnecting/Connecting the Joysticks

NOTE: For this procedure, refer to FIGURE 5.11 on page 45.

NOTE: The joystick connector is located at the rear of the seat frame.

SPJ+ Joysticks

Disconnecting

1.Hold the light GREY collar portion of the joystick connector with one hand and the controller connector on the wheelchair in the other and disconnect them by pulling them apart.

Connecting

WARNING

The joystick connector and controller connector fit together in one way only. DO NOT force them together.

TDX® SI, TDX SI-HD 44 Part No 1154294