Invacare TDX SI manual MPJ+ Joysticks, Connecting

Page 45

SECTION 5—WHEELCHAIR OPERATION

1.Hold the light GREY collar portion of the joystick connector with one hand and the controller connector on the wheelchair in the other and align them.

2.Lightly push to engage the joystick connector and the controller connector.

Light Grey Collar	Controller
	Connector

Joystick Connector

FIGURE 5.11 Disconnecting/Connecting

the Joysticks - SPJ+ Joysticks

MPJ+ Joysticks

NOTE: For this procedure, refer to FIGURE 5.12.

Disconnecting

1.Pull the latch away from the joystick connector.

2.Disconnect the joystick connector from the remaining connectors.

Connecting

NOTE: Ensure the gaskets are installed in the top connector cap and between network connectors.

1.Ensure the latch is pulled away from the network connector.

2.Connect the network connector to the other connectors.

3.Top and Bottom Connectors ‐ Install connector caps onto the network connector.

4.Push the latch in to secure the network connectors and caps.

5.If necessary secure excess cable using tie‐wraps.

Top Connector

Cap

Latch

Gasket

Network
Connectors
Controller	Gasket
Cable

Bottom	Gasket
Connector Cap

FIGURE 5.12 Disconnecting/Connecting

the Joysticks - MPJ+ Joysticks

Part No 1154294

45

TDX® SI, TDX SI-HD

Image 45

Contents TDX SI TDX SI-HD Reference Documents Reference DocumentsManual Table of Contents Safety INSPECTION/TROUBLESHOOTING Wheel Locks Transport Ready Package Trro Register Your ProductSpecial Notes Special NotesMeaning Trro and Trbkts Warnings All Wheelchairs Label LocationsWheelchairs with 22NF Batteries Label LocationsWheelchairs with Trro Wheelchairs without Trro Typical Product Parameters Typical Product ParametersTDX SI HD General Guidelines Repair or Service InformationOperation Information General GuidelinesGeneral Guidelines Electrical Wheelchairs with Trro or Trbkts OnlyGrounding Instructions Charging Batteries BatteriesWeight Training Weight LimitationRain Test EMI Information EMI InformationEMI Information SAFETY/HANDLING of Wheelchairs SAFETY/HANDLING of WheelchairsStability and Balance SAFETY/HANDLING of Wheelchairs Coping with Everyday Obstacles Stability AssistReaching, Leaning and Bending Reaching, Leaning and Bending ForwardPinch Points Reaching, Bending BackwardStairways Transferring To and From Other Seats Transferring To and From Other SeatsSafety Inspection Checklists Safety INSPECTION/ TroubleshootingInspect/Adjust Initially Safety INSPECTION/TROUBLESHOOTINGInspect/Adjust Monthly Inspect/Adjust WeeklyInspect/Adjust Periodically Troubleshooting MechanicalInspect/Adjust Every 18 Months Inspect/Adjust Every 2 YearsInformation Gauge Display Diagnostics Troubleshooting ElectricalSPJ+, SPJ+ w/PSS or SPJ+ w/ACC Joysticks Display Description DefinitionPossible Solution Service Indicator Light DiagnosticsSymptom Probable Cause Solutions MPJ+, PSR+, PSF+ Joysticks or DisplaysBAD Joystick CAL Values DON’T Checking Battery Charge LevelUsing the Joystick to Drive the Wheelchair Turning the Power On/OffWheelchair Operation Operating the WheelchairWheelchair Movement ActionSpeedometer On/Off ButtonSpeed Control Buttons Service IndicatorJoystick Charger/Programming InputDrive Select Toggle Switch MPJ+ Joystick Switches and IndicatorsSelecting the Drive Mode Information Gauge DisplayLCD Display Screens Speed ControlMain Screen Splash ScreenDriving Screen Wheelchair Operation DescriptionRemote Stop Switch Programmable Mono Port 1/2 or External Mode SwitchRemote Mode Reset Switch Connected Devices ScreenRemote On/Off Switch Mode SwitchMemory Card Slot Van Seats Repositioning JoystickAdjustable Asba Seats Disconnecting/Connecting the JoysticksDisconnecting SPJ+ JoysticksMPJ+ Joysticks ConnectingMotor Locks Disengaging/Engaging Motor Lock LeversMotor Locks Disengaging/Engaging the Wheel locks Wheel LocksEngaging DisengagingRemoving/Installing the Footboard Footboard AssemblyInstalling Pinch point may occur when rotating the footboard assemblyRemoving/Installing the Footboard Adjusting the Footboard AngleAdjusting Forks ForksForks Batteries BatteriesFor Wheelchairs Using 22NF Batteries Using the Proper BatteriesReplacing Batteries Wire CutterReplacing Batteries Removing/Installing the Batteries From/Into the Wheelchair Cleaning Battery TerminalsBattery Retention Bracket Removing the Batteries from Wheelchair Installing Batteries into WheelchairInstalling Batteries into Wheelchair When to Charge Batteries SPJ+, SPJ+ w/PSS and SPJ+ w/ACC JoysticksMPJ+ Joystick Charging Batteries Description and Use of Battery ChargersTool Quantity Required ItemsTransport Ready Package Trro Transport Ready Package TrroCompliance Information About Transport Ready PackagesMotor Wheelchair Weight Limit SpecificationsSecuring the Wheelchair to the Vehicle Positioning the Wheelchair in the VehicleSecurement Points Securing the WheelchairWheelchair-Anchored Belts Securing the OccupantWheelchair-Anchored Belts Rating Description Vehicle-Anchored BeltsPositioning Belts Seating SystemTDX SI, TDX SI-HD Limited Warranty Limited Warranty Global Limited Warranty Excluding CanadaUSA Canada Limited Warranty