Invacare TDX SI manual Installing Batteries into Wheelchair

SECTION 10—BATTERIES

5.Slide the battery tray into the wheelchair (FIGURE 10.3).

6.Install the battery door and rear shroud. Refer to Installing the Front Shroud/Battery Retention Bracket and Rear Shroud on page 58.

Battery with Battery	DETAIL “A”
Connector Bracket

Front of the Battery Tray

NOTE: 22NF Batteries shown.

Battery Stop

Rear of the Battery Tray

DETAIL “B”	DETAIL “C”
Connect Front
Battery to
Rear Battery
HERE	Battery
Front	Straps
Battery
Rear Battery

FIGURE 10.4 Installing Batteries into Wheelchair

Installing the Front Shroud/Battery Retention Bracket and Rear Shroud

WARNING

Wheelchairs with TRRO or TRBKTS Only - Battery retention brackets MUST be installed at all times. Otherwise, the wheelchair will not be WC/19 compliant.

After installing front shroud, ensure that the mounting screws on the front shroud/ battery retention bracket are fully engaged into the battery box.

NOTE: For this procedure, refer to FIGURE 10.2 on page 56.

1.Reinstall the front shroud/battery retention bracket onto front of wheelchair frame.

2.Install two mounting screws on the sides of the front shroud/battery retention bracket.

WARNING

When installing batteries, ensure battery connector is securely engaged to the controller connector - otherwise serious personal injury may result.

3.Wheelchairs with Footboards Only: Using the mounting screw and washer, secure the footboard support to the wheelchair frame.

4.Connect the controller to the batteries at the rear of the wheelchair.

TDX® SI, TDX SI-HD 58 Part No 1154294