Invacare Tracer EXIR Footplate Height Adjustment, Spring Button Height Adjustment Figure, Front

Page 22

RIGGINGS

SECTION 3		FRONT RIGGINGS

FOOTPLATE HEIGHT ADJUSTMENT

SPRING BUTTON HEIGHT ADJUSTMENT (FIGURE 2)

NOTE: This procedure applies to the swingaway front riggings and swingaway elevating legrest.

1.Remove the front rigging assembly. Refer to INSTALLING/REMOVING THE FRONT RIGGING in this section of the manual.

NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.

FRONT

2.Pull the cam lock lever UP to UN- LOCKED position.

NOTE: The elevating legrest has two (2) sets of

Front Rigging

release buttons, one (1) set above the other. Each set will be visible one at a time allowing finer footplate height adjustment.

3. Push IN the release buttons and reposi-

tion the footplate assembly to the

Adjustment

Support

Release Button

desired height.

Holes

Footplate

4.	Ensure that the release buttons fully
	protrude from holes on both sides of
	the front rigging support.
5.	Rotate cam lock lever DOWN to
	LOCKED position.

Cam Lock

Lever

Assembly

6.	Repeat this procedure for the other
	footplate, if necessary.
7.	Reinstall the swingaway front rigging
	assembly. Refer to INSTALLING/RE-
	MOVING THE FRONT RIGGING in
	this section of the manual.

NOTE: Swingaway footrest shown.

FIGURE 2 - FOOTPLATE HEIGHT ADJUSTMENT - SPRING BUTTON HEIGHT ADJUSTMENT

BOLT-IN-PLACE HEIGHT ADJUSTMENT (FIGURE 3)

NOTE: This procedure applies to the swingaway footrests and swingaway elevating legrest.

1.Remove the swingaway front rigging. Refer to INSTALLING/REMOVING THE FRONT RIGGINGS in this section of the manual.

NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.

2.Pull the cam lock lever UP to UNLOCKED position.

3.Using a screw driver to hold the riv nut in position, remove the button head screw from the rive nut.

4.Remove the riv nut and button head screw securing the footplate assembly to the front rigging support.

5.Adjust the footplate assembly height by aligning the desired adjustment holes in the upper front rigging support and lower footrest assembly.

Tracer® EXI

22

Part No. 1110547

Image 22

Contents Tracer R EXI Tracer EXI Table of Contents ANTI-TIPPERS/WHEEL Locks Special Notes Special NotesLocationslabel Label LocationsSpecifications SpecificationsGeneral Guidelines Stability ALL ModelsSection General Guidelines Operating Information General Guidelines SectionWeight Limitation Weight TrainingTire Pressure Stability and Balance SAFETY/HANDLING of WheelchairsCoping with Everyday Obstacles Percentage of Weight Distribution Tipping Do not tip the wheelchair without assistanceTipping Curbs Method 2 Wheelchair Without Step Tube Method 1 Wheelchair with Step TubesMethod 2 Wheelchair Without Step Tube Stairways ESCALATORS? SorryTransferring to and from Other Seats Unfolding and Folding the WheelchairFolding Unfolding FoldingSafety Inspection Safety Inspection ChecklistSection Safety Inspection Maintenance Safety Precautions TroubleshootingMaintenance Suggested Maintenance ProceduresSafety Inspection Removing INSTALLING/REMOVING the Front Riggings FigureInstalling Front Riggings SectionBOLT-IN-PLACE Height Adjustment Figure Footplate Height AdjustmentSpring Button Height Adjustment Figure RiggingsFixed Frame Figure Outside of Swingaway Front RiggingRAISING/LOWERING the Elevating Legrest Assembly Figure Heel Loop Replacement FigureSpring Buttons Footplates Detail a Footplates with BOLT-IN-PLACEInside Outside Swingaway Front Rigging Removing Armrest Removing and Installing Armrest FigureInstalling Armrest ArmsSeat and Back Section Replacing Back Upholstery FigureReplacing Seat Upholstery Figure Seat and BackSeat Backand Adjusting the Seat WidthEXI with Swingaway Front Riggings Figure Section Seat and BackDetail B DetailCrossbrace Hardware Detail a Removing Lower Mounting Hardware EXI with Fixed Frame FigureRemoving Upper Mounting Hardware Rear Wheels Section REMOVING/INSTALLING the Rear WheelsPermanent Axles Figure Rear WheelsSection Rear Wheels REPLACING/REPAIRING Rear Wheel TIRE/TUBEReplacing Rear Wheel Handrim Figure WheelsrearFront Casters Section INSTALLING/REPLACING Fork Assemblies FigureAdjusting Forks Figure Front CastersCastersfront REPLACING/REPAIRING Front Caster TIRE/TUBEReplacing Front Casters Figure Section Front CastersANTI-TIPPERS/WHEEL Locks Section INSTALLING/ADJUSTING the ANTI-TIPPERSInstalling the ANTI-TIPPERS Figures 1 ANTI-TIPPERS/WHEEL LocksLOCKSTIPPERS/WHEEL Adjusting the ANTI-TIPPERS FigureSection ANTI-TIPPERS/WHEEL Locks AntiUsing the Patient Operated Disk Wheel Locks Figure USING/ADJUSTING the Disk Wheel LocksAdjusting the Disk Wheel Locks Figure Installing Wheel Lock Shoe Extensions Figure LocksSEAT-TO-FLOOR Height Section Changing SEAT-TO-FLOOR Height FigureSEAT-TO-FLOOR Height Changing SEAT-TO-FLOOR Height Options Section Installing the Seat Positioning Strap FigureOptions Tracer EXI Warranty WarrantyMade in Mexico Canada