Invacare Tracer EXIR manual Replacing Rear Wheel Handrim Figure, Section Rear Wheels, Wheelsrear

Page 32

SECTION 6

REAR WHEELS

 

 

 

REPLACING REAR WHEEL HANDRIM (FIGURE 2)

WHEELSREAR

1.Remove the rear wheel from the wheelchair. Refer to REMOVING/ INSTALLING THE REAR WHEELS in this section of the manual.

2.Remove the mounting screws and washers (not shown) that secure the handrim to the rear wheel.

3.Remove the existing handrim.

4.Install the NEW handrim by reversing the above steps.

5.Reinstall rear wheel to the wheelchair. Refer to REMOVING/INSTALLING THE REAR WHEELS in this section of the manual.

Rear

Mounting Screw

Wheel

 

Handrim

FIGURE 2 - REPLACING REAR

WHEEL HANDRIM

6. Repeat the procedure for the opposite rear wheel if necessary.

REPLACING/REPAIRING REAR WHEEL TIRE/TUBE

WARNING

Replacement of rear wheel tire or tube MUST be performed by a quali- fied technician.

CAUTION

As with any vehicle, the wheels and tires should be checked periodically for cracks and wear, and should be replaced if damaged.

Tracer® EXI

32

Part No. 1110547

Image 32
Contents Tracer R EXI Tracer EXI Table of Contents ANTI-TIPPERS/WHEEL Locks Special Notes Special NotesLocationslabel Label LocationsSpecifications SpecificationsSection General Guidelines Stability ALL ModelsGeneral Guidelines Operating Information General Guidelines SectionTire Pressure Weight TrainingWeight Limitation Coping with Everyday Obstacles SAFETY/HANDLING of WheelchairsStability and Balance Percentage of Weight Distribution Tipping Do not tip the wheelchair without assistanceMethod 2 Wheelchair Without Step Tube Method 1 Wheelchair with Step TubesTipping Curbs Method 2 Wheelchair Without Step Tube Stairways ESCALATORS? SorryTransferring to and from Other Seats Unfolding and Folding the WheelchairFolding Unfolding FoldingSection Safety Inspection Safety Inspection ChecklistSafety Inspection Troubleshooting MaintenanceMaintenance Safety Precautions Suggested Maintenance ProceduresSafety Inspection INSTALLING/REMOVING the Front Riggings Figure InstallingRemoving Front Riggings SectionFootplate Height Adjustment Spring Button Height Adjustment FigureBOLT-IN-PLACE Height Adjustment Figure RiggingsFixed Frame Figure Outside of Swingaway Front RiggingRAISING/LOWERING the Elevating Legrest Assembly Figure Heel Loop Replacement FigureInside Outside Swingaway Front Rigging Detail a Footplates with BOLT-IN-PLACESpring Buttons Footplates Removing and Installing Armrest Figure Installing ArmrestRemoving Armrest ArmsReplacing Back Upholstery Figure Replacing Seat Upholstery FigureSeat and Back Section Seat and BackAdjusting the Seat Width EXI with Swingaway Front Riggings FigureSeat Backand Section Seat and BackCrossbrace Hardware DetailDetail B Removing Upper Mounting Hardware EXI with Fixed Frame FigureDetail a Removing Lower Mounting Hardware REMOVING/INSTALLING the Rear Wheels Permanent Axles FigureRear Wheels Section Rear WheelsREPLACING/REPAIRING Rear Wheel TIRE/TUBE Replacing Rear Wheel Handrim FigureSection Rear Wheels WheelsrearINSTALLING/REPLACING Fork Assemblies Figure Adjusting Forks FigureFront Casters Section Front CastersREPLACING/REPAIRING Front Caster TIRE/TUBE Replacing Front Casters FigureCastersfront Section Front CastersINSTALLING/ADJUSTING the ANTI-TIPPERS Installing the ANTI-TIPPERS Figures 1ANTI-TIPPERS/WHEEL Locks Section ANTI-TIPPERS/WHEEL LocksAdjusting the ANTI-TIPPERS Figure Section ANTI-TIPPERS/WHEEL LocksLOCKSTIPPERS/WHEEL AntiAdjusting the Disk Wheel Locks Figure USING/ADJUSTING the Disk Wheel LocksUsing the Patient Operated Disk Wheel Locks Figure Installing Wheel Lock Shoe Extensions Figure LocksSEAT-TO-FLOOR Height Changing SEAT-TO-FLOOR Height FigureSEAT-TO-FLOOR Height Section Changing SEAT-TO-FLOOR Height Options Installing the Seat Positioning Strap FigureOptions Section Tracer EXI Warranty WarrantyMade in Mexico Canada