Invacare Tracer EXIR manual RAISING/LOWERING the Elevating Legrest Assembly Figure

Page 24

RIGGINGS

SECTION 3

FRONT RIGGINGS

 

 

 

RAISING/LOWERING THE ELEVATING LEGREST ASSEMBLY (FIGURE 5)

WARNING

Ensure hands and fingers are clear of elevating legrest mechanism BEFORE pushing release lever to lower the elevating legrest. Otherwise injury may occur due to pinch points.

The wheelchair user’s leg MUST be supported by an assistant BEFORE attempting to lower legrest.

FRONT

1.To raise the elevating legrest, the assistant should grab hold of the support tube and raise elevating leg- rests until the desired height is ob- tained.

2.To lower the elevating legrest, per- form the following:

A.Support user leg with one (1) hand.

B.Push release lever downward with other hand.

C.Gently, lower user leg down and rest against the legrest.

Release

Lever

Support Tube

FIGURE 5 - ADJUSTING THE

ELEVATING LEGREST ASSEMBLY

HEEL LOOP REPLACEMENT (FIGURE 6)

1.Pull the cam lock lever UP to UNLOCKED position.

2.Perform one (1) of the following as shown in DETAIL "A" of FIGURE 6:

A.FOOTPLATES WITH SPRING BUTTONS:Push IN the release buttons and remove the footplate assembly from the front rigging support.

B.BOLT-IN-PLACE FOOTPLATES:

Using a screw driver to hold the riv nut in position, remove the button head screw from the rive nut.

Remove the riv nut and button head screw securing the footplate assembly to the front rigging support.

3.Remove the mounting screw, spacer and locknut that secure the heel loop to the footplate.

4.Remove EXISTING heel loop from slide tube.

5.Install NEW heel loop onto slide tube.

6.Install the mounting screw, spacer and locknut to secure the heel loop to the footplate Tighten until the spacer is secure.

Tracer® EXI

24

Part No. 1110547

Image 24
Contents Tracer R EXI Tracer EXI Table of Contents ANTI-TIPPERS/WHEEL Locks Special Notes Special NotesLocationslabel Label LocationsSpecifications SpecificationsStability ALL Models General GuidelinesSection General Guidelines Operating Information General Guidelines SectionWeight Training Weight LimitationTire Pressure SAFETY/HANDLING of Wheelchairs Stability and BalanceCoping with Everyday Obstacles Percentage of Weight Distribution Tipping Do not tip the wheelchair without assistanceMethod 1 Wheelchair with Step Tubes Tipping Curbs Method 2 Wheelchair Without Step TubeMethod 2 Wheelchair Without Step Tube Stairways ESCALATORS? SorryTransferring to and from Other Seats Unfolding and Folding the WheelchairFolding Unfolding FoldingSafety Inspection Checklist Safety InspectionSection Safety Inspection Troubleshooting MaintenanceMaintenance Safety Precautions Suggested Maintenance ProceduresSafety Inspection INSTALLING/REMOVING the Front Riggings Figure InstallingRemoving Front Riggings SectionFootplate Height Adjustment Spring Button Height Adjustment FigureBOLT-IN-PLACE Height Adjustment Figure RiggingsFixed Frame Figure Outside of Swingaway Front RiggingRAISING/LOWERING the Elevating Legrest Assembly Figure Heel Loop Replacement FigureDetail a Footplates with BOLT-IN-PLACE Spring Buttons FootplatesInside Outside Swingaway Front Rigging Removing and Installing Armrest Figure Installing ArmrestRemoving Armrest ArmsReplacing Back Upholstery Figure Replacing Seat Upholstery FigureSeat and Back Section Seat and BackAdjusting the Seat Width EXI with Swingaway Front Riggings FigureSeat Backand Section Seat and BackDetail Detail BCrossbrace Hardware EXI with Fixed Frame Figure Detail a Removing Lower Mounting HardwareRemoving Upper Mounting Hardware REMOVING/INSTALLING the Rear Wheels Permanent Axles FigureRear Wheels Section Rear WheelsREPLACING/REPAIRING Rear Wheel TIRE/TUBE Replacing Rear Wheel Handrim FigureSection Rear Wheels WheelsrearINSTALLING/REPLACING Fork Assemblies Figure Adjusting Forks FigureFront Casters Section Front CastersREPLACING/REPAIRING Front Caster TIRE/TUBE Replacing Front Casters FigureCastersfront Section Front CastersINSTALLING/ADJUSTING the ANTI-TIPPERS Installing the ANTI-TIPPERS Figures 1ANTI-TIPPERS/WHEEL Locks Section ANTI-TIPPERS/WHEEL LocksAdjusting the ANTI-TIPPERS Figure Section ANTI-TIPPERS/WHEEL LocksLOCKSTIPPERS/WHEEL AntiUSING/ADJUSTING the Disk Wheel Locks Using the Patient Operated Disk Wheel Locks FigureAdjusting the Disk Wheel Locks Figure Installing Wheel Lock Shoe Extensions Figure LocksChanging SEAT-TO-FLOOR Height Figure SEAT-TO-FLOOR Height SectionSEAT-TO-FLOOR Height Changing SEAT-TO-FLOOR Height Installing the Seat Positioning Strap Figure Options SectionOptions Tracer EXI Warranty WarrantyMade in Mexico Canada