LOCKS
SECTION 8 | ||
|
|
|
NOTE: Any wheel lock adjustment should embed the wheel lock shoe at least
7.Repeat STEPS
8.If the measurement of
9. | Repeat STEPS |
10. | If wheel lock is unable to properly |
| engage the wheel it may be necessary |
| to install wheel lock shoe extensions. |
| Refer to INSTALLING WHEEL LOCK |
| SHOE EXTENSIONS in this sectoion |
| of the manual. |
11. | Repeat STEPS |
12. | Repeat STEPS |
| wheel lock. |
13. | Engage both wheel locks and ensusre |
| the occupied wheelchair is held in |
DETAIL "A" - | |
WHEEL LOCK | |
SHOE | pneumatic tires) |
ENGAGEMENT | Wheel Lock |
| |
| Shoe |
| Tire |
Mounting Positions | Bolt and Locknut |
| |
| Wheel Lock Handle |
Wheel
LockWheel
Lock
place when pushed. |
Rear
Shoe
WARNING
If wheel locks do not hold the occu- pied wheelchair in place contact a qualified technician. - other wise injury or damage may occur.
Wheel
FIGURE 4 - ADJUSTING THE PATIENT OPERATED WHEEL LOCKS
INSTALLING WHEEL LOCK SHOE EXTENSIONS (FIGURE 5)
1.Loosen the two (2) set screws on the wheel lock shoe extension until the set screws do not protrude into the slot.
2.Insert the disk wheel lock shoe into the slot in the shoe extension.
NOTE: Ensure the pointed end of the wheel lock shoe extension is facing toward the rear wheel.
3.Position the wheel lock shoe exten- sion so the outside edge is flush with the end of the wheel lock shoe.
4.Securely tighten the two (2) set screws to secure the wheel lock shoe exten- sion to the wheel lock shoes.
Wheel Lock Shoe Extension | Set | |
Screws | ||
Pointed End of |
| |
Wheel Lock Shoe | Slot | |
Extension | ||
|
FIGURE 5 - INSTALLING WHEEL
LOCK SHOE EXTENSION
Tracer® EXI | 38 | Part No. 1110547 |