FRONT RIGGINGS | SECTION 3 |
6.From the outside of the swingaway front rigging, insert the riv nut through both the front rigging support and the footplate assembly.
7.From the inside of the swingaway front rigging, insert the button head screw through the appropreate adjustment hole and thread into the riv nut.
8.Using a screwdriver to hold the riv nut in position, securely tighten the button head screw. Torque to 32
FRONT
9.Rotate cam lock lever DOWN to LOCKED position.
10.Repeat STEPS
|
| Front Rigging |
| Front Rigging | Support |
| Button Head | |
| Support | |
|
| Screw |
Button Head Screw |
|
|
| Riv Nut | Adjustment |
Adjustment Hole |
| |
| Hole | |
|
| |
Cam Lock Lever |
|
|
|
| Footplate |
INSIDE OF |
| Assembly |
|
| |
SWINGAWAY |
|
|
FRONT | NOTE: Swingaway footrests shown. | |
RIGGING |
Riv Nut
Footplate Assembly
OUTSIDE OF SWINGAWAY FRONT RIGGING
RIGGINGS
FIGURE 3 - FOOTPLATE HEIGHT ADJUSTMENT - BOLT-IN-PLACE
HEIGHT ADJUSTMENT
FIXED FRAME (FIGURE 4)
1.Remove impact guards and/or calf strap, if necessary.
2.Loosen, but do not remove the bolt and locknut that secure the lower footrest assembly to the upper footrest support.
3.Reposition the lower footrest assembly to the desired height.
4.Securely tighten the bolt and locknut.
Wheelchair
Frame
Footplate
Assembly
Bolt and
Locknut
FIGURE 4 - FOOTPLATE HEIGHT ADJUSTMENT - FIXED FRAME
5.Repeat this procedure for the other footrest, if necessary.
6.Replace impact guards and/or calf strap, if necessary.
Part No. 1110547 | 23 | Tracer® EXI |