Invacare Pronto M91 Base manual LCD Display

SECTION 5—WHEELCHAIR OPERATION

Refer to LCD Display table on page 39 for descriptions of information shown.

	LCD DISPLAY
ITEM	DESCRIPTION
DRIVE NAME	This field shows the currently selected Drive’s Name.
	Available choices are as follows:
	Drive 1*
	Drive 2*
	Drive 3*
	Drive 4*
	“No Drive” selected via the programmer.
	*NOTE: Drive names can be customized. Actual drive names may display differently.
BATTERY LEVEL	This symbol shows the Battery Level and will change depending on the available
INDICATOR	battery power.
	This indicator is shown on every screen.
STATUS MESSAGE	This area displays status or instructions.
STATUS INDICATOR	The status indicator will show a “Warning” (exclamation point inside a triangle)
	indicator when the chair has a condition that requires attention.
	The status indicator will show a “STOP” sign when a serious condition exists. The
	chair will not be allowed to operate.
	The status indicator shows an Attendant Icon if the attendant’s override switch is
	active.
MODES	The dotted-box shows the area that contains the available “modes” in the cur-
	rently selected drive. The modes are programmed for each drive and are based
	upon the configuration of the chair.
	These modes are highlighted when the Mode is active. The operator changes
	modes by pressing the Mode Select Switch.
	The available modes are as follows:
	Drive Mode (1 through 4)
	Automatic Positioning
	Actuator Control Switch Mode (4-switch, 4-switch 2 levels, etc.)
	ECU Output Activated (1 through 4)
	RIM Mode Activated
	Drive Select Mode Activated
	No Driving

Part No 1143153 39 Pronto® M91™Base with SureStep®