SECTION 8—SHROUD/WHEELS
Engaging/Disengaging Motor Release Lever
WARNING
DO NOT engage or disengage the motor release lever until the On/Off switch on the joystick is in the Off position.
CAUTION
Ensure both motor release levers are fully engaged before driving the wheelchair
NOTE: For this procedure, refer to FIGURE 8.2.
NOTE: The motor lock disengagement/engagement allows freewheeling or joystick controlled operation. Freewheeling allows an attendant to maneuver the wheelchair without power.
1.Locate the motor release handles on the motors protruding through the shrouds by the rear springs.
2.Perform one of the following:
•To disengage the motor release levers ‐ Slide the motor lock lever towards the outside of the wheelchair (free wheel position) (Detail “A”).
NOTE: This allows the wheelchair to freewheel for pushing if necessary
•To engage the motor release levers ‐ Slide the motor lock handles towards the center of the wheelchair (drive position) (Detail “A”).
NOTE: This allows the motors to drive the wheels.
Motor
Release
Lever
DETAIL “A”
Towards Center
of Wheelchair
Towards
Outside of
Wheelchair
Motor Locks Disengaged 
(Freewheel Mode)
Motor Locks Engaged
(Drive Mode)
FIGURE 8.2 Engaging/Disengaging Motor Release Lever
Pronto® M91™Base with SureStep® | 54 | Part No 1143153 |