Invacare Pronto M91 Base manual Connecting/Disconnecting the Battery Wiring Harness

SECTION 9—BATTERIES

7.Reposition battery terminal covers over battery post(s).

8.Using new tie‐wraps, secure the terminal covers to the battery terminals as shown in FIGURE 9.3.

9.Repeat STEPS 1‐8 to install and connect the rear battery to the rear battery harness.

NEGATIVE (-)			POSITIVE (+)
Battery Cable			Battery Cable,
			Mounting Screw with
NEGATIVE (-)	Nut		Fuse Hardware
Battery Terminal
			Tie-Wrap
Mounting
Screw
			Locknut
	Tie-Wrap
		Battery	POSITIVE (+)
			Battery Terminal

FIGURE 9.3 Connecting/Disconnecting the Battery Wiring Harness

Disconnecting

NOTE: For this procedure, refer to FIGURE 9.3 on page 61.

1.Remove the existing tie‐wraps that secure the battery terminal covers to the battery terminals.

2.Peel back RED battery terminal cover to expose RED battery cable connection to battery terminal.

3.Peel back BLACK battery terminal cover from BLACK battery cable on front battery or GREY battery terminal cover from BLACK battery cable on rear battery.

4.Remove the mounting screws and nuts that secure the POSITIVE (+) RED battery cable to the POSITIVE (+) battery terminal/post as shown in FIGURE 9.3.

5.Remove the mounting screws and nuts that secure the NEGATIVE (‐) BLACK battery cable to the NEGATIVE (‐) battery terminal/post as shown in FIGURE 9.3.

6.Set wiring harness aside.

7.Repeat STEPS 1‐6 to disconnect the rear battery from the rear battery harness.

Part No 1143153 61 Pronto® M91™Base with SureStep®