Invacare Pronto M91 Base manual Batteries

Page 56

SECTION 9—BATTERIES

SECTION 9—BATTERIES

WARNING

Make sure power to the wheelchair is Off before performing this section.

NEVER allow any of your tools and/or battery cable(s) to contact both battery terminal(s)/post(s) at the same time. An electrical short may occur and serious personal injury or damage may occur.

The use of rubber gloves is recommended when working with batteries.

Always use a battery lifting strap when lifting a battery. It is the most convenient method and assures that the battery acid will not spill. It also helps to prolong the life of the battery.

DO NOT tip the batteries. Keep the batteries in an upright position. Avoid storage or use near external flame or combustible products.

Invacare strongly recommends that battery installation and battery replacement always be done by a qualified technician.

After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

Battery terminal configuration shown below MUST be used. Batteries that have the reversed terminal configuration MUST NOT be used - otherwise serious injury or damage may occur.

Mounting Holes

NEGATIVE (-)

Battery Terminal

POSITIVE

(+) Battery

Terminal

DO NOT Use

POSITIVE

(+)Battery Terminal

NEGATIVE

(-) Battery

Terminal

CAUTION

When connecting the battery cables to the battery(ies), the battery cable(s) MUST be connected to the battery terminal(s)/post(s) as shown in FIGURE 9.3 otherwise damage to the battery may result.

For proper battery connection, batteries MUST use post style terminals with mounting holes through the terminal.

NOTE: If there is battery acid in the bottom of the battery tray or on the sides of the battery(ies), apply baking soda to these areas to neutralize the battery acid. Before reinstalling the existing or new battery(ies), clean the baking soda from the battery tray or battery(ies) being sure to avoid contact with skin and eyes. Determine source of contamination. NEVER install/reinstall a battery with a cracked or otherwise damaged case.

Pronto® M91™Base with SureStep®

56

Part No 1143153

Image 56
Contents Pronto M91Base With SureStep Manual Reference DocumentsReference Documents Table of Contents Table of Contents Wheelchair OperationSeat Register Your Product Transport Ready PackageMeaning Special NotesSpecial Notes Special Notes Label Locations Label LocationsM91 Standard M91 Heavy Duty Wheelchairs With Trro Wheelchairs Without Trro Typical Product Parameters Pronto M91Typical Product Parameters InchController Settings/Repair or Service Accessories InformationGeneral Guidelines Operation InformationGeneral Guidelines Batteries Grounding Instructions Charging BatteriesWeight Training Weight LimitationModel Weight Limitation Rain TestEMI Information EMI InformationEMI Information Stability and Balance SAFETY/HANDLING of WheelchairsSAFETY/HANDLING of Wheelchairs Coping With Everyday Obstacles Coping With Everyday ObstaclesPinch Points Pinch PointsLifting/Stairways Lifting/Stairways Hand Hold SupportsTransferring To and From Other Seats Transferring To and From Other SeatsReaching, Leaning and Bending Forward Reaching and Bending BackwardSafety INSPECTION/ Troubleshooting Safety Inspection ChecklistsInspect/Adjust Initially Safety INSPECTION/TROUBLESHOOTINGInspect/Adjust Periodically Inspect/Adjust WeeklyInspect/Adjust Monthly Troubleshooting Mechanical Troubleshooting ElectricalSolutions SPJ+, SPJ+ w/PSS or SPJ+ w/ACC JoysticksPossible Solution Display Description DefinitionSymptom Probable Cause Solutions MPJ+, PSR+, PSF+ Joysticks or DisplaysChecking Battery Charge Level DON’TTurning the Power On/Off Wheelchair OperationOperating the Wheelchair Wheelchair OperationUsing the Joystick to Drive the Wheelchair Movement ActionOn/Off Button SpeedometerService Indicator Speed Control ButtonsJoystick Charger/Programming InputInformation Gauge Display Speed Control MPJ+ Joystick Switches and IndicatorsDrive Select Toggle Switch LCD Display Screens Splash ScreenLCD Display Driving Screen Wheelchair Operation Icon Description Programmable Mono Port 1/2 or External Mode SwitchRemote On/Off Switch Memory Card Slot Mode SwitchPreparing the Joystick for Use Van Seat Adjustable Asba SeatRepositioning the Joystick Connecting Disconnecting/Connecting the JoysticksSPJ+ Joysticks Disconnecting Disconnecting MPJ+ JoysticksRemoving/Installing the Seat Assembly SeatRemoving SeatTilting the Seat Assembly InstallingTilting the Seat Assembly Back Tilting the Seat Assembly ForwardFootboard Assembly Footboard AssemblyRemoving/Installing the Footboard Assembly Adjusting the Footboard Assembly AngleAdjusting the Footboard Assembly Depth DepthRemoving/Installing the Shrouds SHROUD/WHEELSReplacing the Flat Free Tires on the Wheel Rim SHROUD/WHEELSRemoving/Installing the Shrouds Engaging/Disengaging Motor Release Lever Engaging/Disengaging Motor Release LeverAdjusting Forks Replacing Front/Rear Caster AssembliesBatteries BatteriesInstalling/Removing the Batteries Tool QTY CommentsBatteries with/without Lifting straps Tie Wrap Connecting/Disconnecting the Battery Wiring Harness Connecting/Disconnecting the Battery Wiring Harness MPJ+ Joystick When to Charge BatteriesSPJ+ Joysticks Charging Batteries Battery Charger Operation On-Board Battery ChargerIndependent Charger To Wall OutletRequired Items Tool QuantityTransport Ready Package Transport Ready PackageSpecifications Wheelchair Weight LimitAbout Transport Ready Packages Compliance InformationSecuring the Wheelchair to the Vehicle Positioning the Wheelchair in the VehicleSecurement Points Securing the WheelchairSecuring the Occupant Wheelchair-Anchored BeltsVehicle-Anchored Belts Seating SystemPositioning Belts Positioning BeltsPronto M91Base with SureStep Global Limited Warranty Excluding Canada Global Limited Warranty Excluding CanadaCanada Limited Warranty USA