SECTION 7—FOOTBOARD ASSEMBLY
Depth
NOTE: For this procedure, refer to FIGURE 7.3.
1.Remove the quick release pin that secures the footboard assembly to the wheelchair frame.
WARNING
Make sure the detent balls of the quick release pin are fully released and protruding past the outer edge of the tube before operating the wheelchair. Otherwise, injury and/or damage may result.
Keep detent balls clean.
2.Adjust footboard to one of three mounting positions.
3.Install the quick release pin. Make sure the detent balls of the quick release pin are fully released and past the outer edge of the tube (Detail “A”).
Mounting | Wheelchair Frame | |
Hole |
| |
Three |
| |
Depth |
| |
Adjustment |
| |
Holes |
| |
Quick | Detent | |
Release | ||
Ball | ||
Pin | ||
| ||
| Footboard | |
| Assembly |
DETAIL “A” - BOTTOM
VIEW OF FOOTBOARD
Quick Release Pin
Outer Edge | Detent Balls | |
of Tube | ||
|
FIGURE 7.3 Adjusting the Footboard Assembly - Depth
Part No 1143153 | 51 | Pronto® M91™Base with SureStep® |