Invacare 220 manual Removing/Installing the Deluxe Seat

Page 31

SECTION 7—SEAT AND ARMS

Removing/Installing the Deluxe Seat

WARNING

Before use, ensure that the seat is in the locked position. The seat lever MUST be pulled up to the 90° position to allow the seat to drop into the locked position. Oth- erwise, a fall from the scooter could occur causing bodily injury and/or damage to the scooter.

NOTE: For this procedure, refer to FIGURE 7.3.

Removing

1.Fold down seat back.

2.Pull up the seat lock lever to 90°.

3.Lift the seat assembly up and away from the seat post.

Installing

1.Lower the seat assembly onto the seat post.

2.Pull up the seat lock lever to 90° to allow the seat to drop into the locked position.

3.Lift up on seat assembly to ensure the seat is secure.

Seat Lock Lever in

Unlocked Position

Seat

Assembly

Seat Post

Seat Lock Lever

in Locked

NOTE: Tiller not shown for clarity.

FIGURE 7.3 - Removing/Installing the Deluxe Seat

Part No. 1125053

31

220

Image 31

Contents HMVHighly Maneuverable Vehicle 220 Table of Contents Tiller Adjustment Transporting Register Your Product Product Registration Form Fold here Cut Along Line TIE-DOWN Restraints and Seat Restraints Special Notes220 Typical Product ParametersLabel Locations General Guidelines Repair or Service InformationOperation Information General Guidelines Grounding Instructions ElectricalRain Test Weight TrainingWeight Limitation BatteriesEMI Information EMI Information Percentage of Weight Distribution SAFETY/HANDLING of Powered ScootersStability and Balance Escalators StairwaysSafety Inspection Checklists Safety InspectionInspect/Adjust Initially Inspect/Adjust Monthly Inspect/Adjust WeeklyInspect/Adjust Periodically Suggested Maintenance Procedures Maintenance and TroubleshootingSymptom Probable Cause Solution TroubleshootingControl Panel Operation of the Powered ScooterOperating the Scooter Engaging/Disengaging the Brake Release Lever Engaging/Disengaging the Brake Release Lever Resetting the Circuit BreakerRemoving Removing/Installing/Adjusting the Padded SeatInstalling/Adjusting Seat Height Seat and ArmsFolding Folding/Unfolding the Back Padded Seat OnlyUnfolding Installing Removing/Installing the Deluxe SeatAdjusting 90 Seat Swivel Deluxe Seat Only Adjusting Seat Height Deluxe Seat OnlyAdjusting 90 Seat Swivel Deluxe Seat Only Removing/Installing the Arms Deluxe Seat OnlyReplacing Armrest Pads Deluxe Seat Only Removing/Installing the Arms Deluxe Seat OnlyAdjusting the Tiller Angle Tiller AdjustmentWheels and Casters Removing/Installing the Drive WheelsRemoving/Installing the Drive Wheels Removing/Installing the Front WheelRemoving/Installing the Fork Removing/Installing the ForkRemoving/Installing the Caster Assemblies Removing/Installing the Caster AssembliesBatteries Recommended Battery TypeRecommended Battery Type Removing/Installing the Battery BoxRemoving/Installing the Batteries Charging the Batteries Inhibit RED Battery Charger Circuit ConnectorCharging the Batteries Assembling TransportingTransporting the Scooter DisassemblingTransporting the Scooter Installing/Removing the Crutch/Cane Holder Scooter AccessoriesInstalling/Removing the Crutch/Cane Holder Installing/Removing the Safety FlagInstalling/Removing the Walker Holder Installing/Removing/Using the Walker HolderUsing the Walker Holder Installing/Removing the Rear Mounted Basket Installing/Removing the Rear Mounted BasketLimited Warranty Product Made Taiwan