Invacare 220 manual Removing/Installing the Front Wheel, Removing/Installing the Drive Wheels

Page 37

SECTION 9—WHEELS AND CASTERS

Scooter Frame

Warning: Pinch

Point

Drive Wheel

Washer

Drive

ShaftMounting

Screw

Keystock

FIGURE 9.1 Removing/Installing the Drive Wheels

Removing/Installing the Front Wheel

NOTE: For this procedure, refer to FIGURE 9.2.

NOTE: Take note of position and orientation of wheel and mounting hardware before removing.

Removing

1.Turn power off and remove the key from the ignition.

2.Place the front of the powered scooter up on blocks so that the front wheel is off the ground.

3.Remove the mounting screw, locknut and two (2) spacers that secure the front wheel to the fork.

4.Remove the front wheel from the fork.

Fork

Mounting

Fork

Screw

Mounting

Hole

Spacer	Spacer

	Locknut	Front
	Locknut	Wheel
		Wheel

FIGURE 9.2 Removing/Installing the Front

Wheel

Installing

1.Align the front wheel with the fork mounting hole.

2.Using the mounting screw, locknut and two (2) spacers, secure the front wheel to the fork.

3.Securely tighten the front wheel mounting hardware.

Part No. 1125053

37

220

Image 37

Contents HMVHighly Maneuverable Vehicle 220 Table of Contents Tiller Adjustment Transporting Register Your Product Product Registration Form Fold here Cut Along Line TIE-DOWN Restraints and Seat Restraints Special Notes220 Typical Product ParametersLabel Locations General Guidelines Repair or Service InformationOperation Information General Guidelines Grounding Instructions ElectricalWeight Limitation Weight TrainingBatteries Rain TestEMI Information EMI Information Percentage of Weight Distribution SAFETY/HANDLING of Powered ScootersStability and Balance Escalators StairwaysSafety Inspection Checklists Safety InspectionInspect/Adjust Initially Inspect/Adjust Monthly Inspect/Adjust WeeklyInspect/Adjust Periodically Suggested Maintenance Procedures Maintenance and TroubleshootingSymptom Probable Cause Solution TroubleshootingControl Panel Operation of the Powered ScooterOperating the Scooter Engaging/Disengaging the Brake Release Lever Engaging/Disengaging the Brake Release Lever Resetting the Circuit BreakerInstalling/Adjusting Seat Height Removing/Installing/Adjusting the Padded SeatSeat and Arms RemovingFolding Folding/Unfolding the Back Padded Seat OnlyUnfolding Installing Removing/Installing the Deluxe SeatAdjusting 90 Seat Swivel Deluxe Seat Only Adjusting Seat Height Deluxe Seat OnlyAdjusting 90 Seat Swivel Deluxe Seat Only Removing/Installing the Arms Deluxe Seat OnlyReplacing Armrest Pads Deluxe Seat Only Removing/Installing the Arms Deluxe Seat OnlyAdjusting the Tiller Angle Tiller AdjustmentWheels and Casters Removing/Installing the Drive WheelsRemoving/Installing the Drive Wheels Removing/Installing the Front WheelRemoving/Installing the Fork Removing/Installing the ForkRemoving/Installing the Caster Assemblies Removing/Installing the Caster AssembliesBatteries Recommended Battery TypeRecommended Battery Type Removing/Installing the Battery BoxRemoving/Installing the Batteries Charging the Batteries Inhibit RED Battery Charger Circuit ConnectorCharging the Batteries Transporting the Scooter TransportingDisassembling AssemblingTransporting the Scooter Installing/Removing the Crutch/Cane Holder Scooter AccessoriesInstalling/Removing the Crutch/Cane Holder Installing/Removing the Safety FlagInstalling/Removing the Walker Holder Installing/Removing/Using the Walker HolderUsing the Walker Holder Installing/Removing the Rear Mounted Basket Installing/Removing the Rear Mounted BasketLimited Warranty Product Made Taiwan