Invacare 220 Installing/Removing/Using the Walker Holder, Installing/Removing the Walker Holder

SECTION 12—SCOOTER ACCESSORIES

Installing/Removing/Using the Walker Holder

INSTALLATION WARNINGS

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely.

The installation of the walker holder onto the back of the scooter seat significantly increases the length of the scooter. When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise, injury and/or damage to the surrounding property may result.

Installing/Removing the Walker Holder

NOTE: Reverse this procedure to remove the walker holder.

NOTE: For this procedure, refer to FIGURE 12.3.

1. If necessary, loosen but DO NOT
remove the mounting knob.	Walker Holder	Seat
		Seat

2.Install the walker holder into the accessory tube.

3.Thread the mounting knob into the

welded nut on the accessory tube.

Securely tighten.	Mounting
	Knob
	Accessory
	Tube

Using the Walker Holder

NOTE: For this procedure, refer to FIGURE 12.4.

1.Fold walker. Refer to walker instructions.

NOTE: Walker MUST be folded before using walker holder.

2.Hang folded walker on walker holder hooks.

3.Secure walker with hook and loop straps.

FIGURE 12.3 Installing/Removing the

Walker Holder

Hook

Hook and

Loop Strap

FIGURE 12.4 Using the Walker Holder

Part No. 1125053 49 220