Invacare 1085144 Installing the Bath Lift into the Bathtub Figure, Steps

DO NOT Secure Here					STEP 2			Spade Connector Wire Wrap
			Current			Mounting Screw			STEPS 2-3
				Limit
				Device			Mounting
	Secure Here				STEPS 1 - 3		Bracket		Pendant
Pendant
									Cable
		RED Spade			BLACK Spade
					Connector Wire
		Connector			(STEP 1)	Motor Shroud			STEPS 4-6
	Upper	Wire
					To Current Limit		Washer
	Spade	(STEP 1)
					Device
							Self-locking		Machine
									Screw
							Screws
					Secure Pendant
Nut					Cable and Spade
					Connector Wire
					Wrap Together				Washer
					(STEP 2)
			Mounting
Mounting			Bracket		Mounting
					Screws
Holes
Lower Spade
					Pendant			Motor
				FIGURE 8 - INSTALLING THE MOTOR SHROUD

Installing the Bath Lift into the Bathtub (FIGURE 9)

WARNING

ALWAYS lower the bath lift frame to the lowest position BEFORE performing this procedure. Otherwise, the bath lift frame may tip during installation and injury or damage may occur.

The frame MUST be placed into an EMPTY bathtub.

1.Clean tub and wipe suction cups with a damp cloth.

2.Press the DOWN button on the pendant to lower the bath lift to the lowest position.

3.Grasp the handgrip on the battery pack and pull upwards to remove it from the motor shroud as shown in FIGURE 9.

4.Place the frame into the bathtub.

5.Perform the following steps to position the frame in the bathtub:

A.Position the rubber pads of the frame just in front of the curve at the bottom of the back of the bathtub.

B.Install the seat. Refer to INSTALLING THE SEAT in this instruction sheet.

C.Position the frame to align the line on the entry/ exit side flap with the inside edge of the bathtub as shown in DETAIL "G" of FIGURE 9.

WARNING

The frame must be positioned so that the side flap of the seat on the entry/ exit side of the bathtub is fully sup- ported by the side of the bathtub. The inside edge of the bathtub MUST be aligned with the line on this side flap.

D.Ensure the rubber pads and suction cups are positioned flat on the bottom of the bathtub.

NOTE: Pull up on suction cup loops to release suc- tion cups from bathtub bottom.

6.Press firmly down onto the two (2) front suction cups to attach the frame securely to the bottom of the bath.

6