SECTION
4.Momentarily push DOWN on the outer ring (sleeve) of the connector fillport to reset the connector as shown in FIGURE 4.2.
NOTE: If the outer ring (sleeve) is in the UP position (GREEN dots not visible), the connector fillport will not be able to accept the cylinder fillport. Pushing DOWN momentarily will reset the connector fillport (GREEN dots visible) to accept the cylinder fillport.
PUSH | Outer Ring (Sleeve) |
DOWN |
|
| Connector Fillport |
GREEN Dots |
|
| BEFORE |
| COUPLING |
| CYLINDER, |
| PUSH DOWN |
| ON SLEEVE |
| UNTIL |
| GREEN DOTS |
| ARE VISIBLE. |
FIGURE 4.2 Resetting Connector Fillport
5.Grasp the cylinder/regulator assembly in the area behind the cylinder gauge (FIGURE 4.3).
6.Position the cylinder in the compressor cradle (FIGURE 4.3).
7.Align the cylinder fillport with the connector fillport (FIGURE 4.3).
8.Pull UP on the outer ring (sleeve) of the connector fillport while pushing DOWN on the cylinder/regulator assembly to couple the cylinder fillport into the connector fillport (FIGURE 4.3).
NOTE: The cylinder is properly connected when an audible “click” is heard.
Oxygen Conserving Cylinder | 14 | Part No 1143247 |