Invacare HF2PCM2KIT manual Fillport Covers

Page 17

SECTION 4—INSPECTION AND COMPRESSOR INTERFACE

5.When the cylinder fillport is disconnected from the connector fillport, release the outer ring (sleeve) of the connector fillport and use two hands to remove the cylinder from the compressor cradle.

WARNING

The fillport cover on the connector fillport and the cylinder fillport MUST be replaced after filling and whenever not in use. If either of the fillport covers are missing contact your healthcare provider before using.

6.Place the fillport covers onto the connector fillport and cylinder fillport.

7.Examine the cylinder gauge to ensure cylinder is full (needle pointing into GREEN area). If the cylinder is not full, perform the following:

Repeat Connecting the Cylinder to the Compressor on page 13.

If cylinder is not full after second attempt to fill, contact the provider.

Cylinder Fillport Cover

Connector Fillport Cover

FIGURE 4.5 Fillport Covers

Part No 1143247

17

Oxygen Conserving Cylinder

Image 17
Contents HomeFill Oxygen Conserving Cylinder Oxygen Conserving Cylinder Table of Contents Intended USE Special NotesReceiving Inspection General Guidelines General Guidelines General Guidelines Product Diagram FeaturesTypical Product Parameters Cylinder Prefill Inspection Inspection and Compressor InterfaceExternal Examination External Examination Connecting/Disconnecting the Cylinder to/from the Compressor Outer Ring Sleeve Connecting the Cylinder to the Compressor Disconnecting the Cylinder from the Compressor Fillport Covers Changing the Carrying Position of the Cylinder Changing the Carrying Position of the Cylinder Cleaning the Cylinder Bag Operating Instructions Operating Instructions Maintenance Cylinder Fill Times TroubleshootingCylinder Fill Times Limited Warranty Limited Warranty USA