Invacare HF2PCM2KIT manual Disconnecting the Cylinder from the Compressor

Page 16

SECTION 4—INSPECTION AND COMPRESSOR INTERFACE

Disconnecting the Cylinder from the Compressor

WARNING

NEVER use tools of any kind to connect/disconnect the cylinder and the compressor. Otherwise, severe injury and/or damage may occur.

NOTE: For this procedure, refer to FIGURE 4.4 on page 16.

1.Press the compressor power switch to the Off (O) position.

2.Grasp the cylinder/regulator assembly in the area behind the cylinder gauge.

3.With the other hand, grasp the outer ring (sleeve) of the connector fillport and push DOWN.

4.Lift up on the cylinder/regulator assembly to remove from the connector fillport.

 

Cylinder/Regulator

 

 

Assembly

PUSH DOWN

Cylinder

 

 

Gauge

Cylinder

Outer Ring

 

(Sleeve)

 

Fillport

Compressor

 

 

 

Connector

Fillport

FIGURE 4.4 Disconnecting the Cylinder from the Compressor

Oxygen Conserving Cylinder

16

Part No 1143247

Page 15 Page 17
Image 16
Page 15 Page 17
Contents HomeFill Oxygen Conserving Cylinder Oxygen Conserving Cylinder Table of Contents Receiving Inspection Special NotesIntended USE General Guidelines General Guidelines General Guidelines Features Product DiagramTypical Product Parameters Inspection and Compressor Interface Cylinder Prefill InspectionExternal Examination External Examination Connecting/Disconnecting the Cylinder to/from the Compressor Outer Ring Sleeve Connecting the Cylinder to the Compressor Disconnecting the Cylinder from the Compressor Fillport Covers Changing the Carrying Position of the Cylinder Changing the Carrying Position of the Cylinder Cleaning the Cylinder Bag Operating Instructions Operating Instructions Maintenance Troubleshooting Cylinder Fill TimesCylinder Fill Times Limited Warranty Limited Warranty USA
Top Page Image Contents