Toshiba SL-9000-FFR-US, SL-9000N-FFR-QR, SL-9000N-FFR-CA, SL-9000-FFR-QR, EO1-31001 LON System Mode

16. ERROR MESSAGE TABLE

								16. ERROR MESSAGE TABLE
●	CMT Operation Mode
		Message			Cause		Solution
				Mismatch of the model type.
				Mismatch of the base unit.
		MISMATCH SCALE SPEC		Mismatch of the VERSION.		Press the	CLEAR	key.
				Mismatch of the
				TRANSMITTING DATA.
				Mismatch of the scale capacity.
				Parity error
				Framing error
		BAD TAPE OR CMT				Press the		key.
				Overrun error			CLEAR
				Data error
				Two or More Hardware error
		TIME OUT ERROR		Time out error		Press the	CLEAR	key.
●	LON System Mode
		Error message			Cause		Solution		M	BM/S
		COMMUNICATION	1. The power of the master or			1. Turn the power of the master
		ERROR		backup master scale is not		or backup master scale ON.
				turned ON.		Connect them with each
				They are not connected with		other or turn the scale in-line.			○	○
				each other or in off-line state.		2. Call your authorized service
			2. LON cable is broken.			representative.
		SEQUENCE ERROR	The power was not turned OFF and			Turn the power switch OFF and			○	○
			ON again after setting ID #.			ON again.
		SEQUENCE NO.	Text data number is incorrect.			Call your authorized service			―	○
		ERROR				representative.
		MASTER BUSY	Registration job is performed on a			1. Quit reset job on the master
			satellite scale while reset job is			scale.			―	○
			performed on the master scale.			2. Quit registration job on the
						satellite scale.
		BACKUP MASTER	The backup master does not have			Down load PLU from the master
		NOT RESET	same PLU with the master scale.			to the backup master scale.			○	―
						Then run the reset operation
						again.
		TEXT ERROR ##	1. Error text is found.			Call your authorized service
			02:		Sequence No. error	representative.
			05:		LRC error
			08:		Text error				○	○
			09:		Command error
			2. The master scale differs from
				other scale in ROM version.
					M: Master scale BM: Backup master scale S: Satellite scale

16- 3