In standby (system not running) : Pressing F1 runs a water flushing cycle. X.X indicates the software version (e.g. 2.1)
Display:
After a few minutes, switch off and on again with the osmosis pump switch.
In stand by: hold down UP/DOWN together to enter programming mode:
(in all the following procedures: UP/DOWN changes the value, ENTER saves and continues, F1 continues without saving).
Programming procedures: >>>>>>>>>>>>>>>>>>>>>>>>
X.X indicates the software version (e.g. 2.1)
Display: Program filtration hours
Press ENTER or F1: Flussaggio auto (auto flush):
This is an auto flush cycle run by the system to prevent stagnation in the circuit. After the set number of hours, the solenoid valves open to flush/refresh the water in the circuit.
- 47 -