Press ENTER or F1:
Stop motore se in moto per … (Stop motor after …) The following two messages concern the osmosis pump motor condition. Set = 0 to exclude this mode; if the value is not 0, the motor stops running after having run continuously for the set period, then starts again.
After two seconds, the system displays:>>>>>>>>>>>>>>
Press ENTER or F1:
If the conductivity value remains below set value, no alarm trips, otherwise an alarm displays.>>>>>>>>>>>>>>>>>>>
Press ENTER or F1:
Set number of pulses per litre for the product flow meter.>>>>>>>>>>>>>>>>>>>>>>>>>>
Press ENTER or F1:
Set number of pulses per litre for the waste flow meter.>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Press ENTER or F1:
Set minimum production below which a fault is reported.>>>>>>>>>>>>>>>>>>>>>>>>>>>>
- 48 -