Smeg WO-01 manual General warnings

Page 4

1. General warnings

STORAGE:

THE PACKED APPLIANCE MUST BE STORED IN A DRY, CONDENSATION-FREE AREA, UNDER COVER. THE ADMITTED STORAGE TEMPERATURE IS 4-50°C.

ALWAYS DISCONNECT ELECTRICAL POWER BEFORE WORKING ON THE APPLIANCE OR DISASSEMBLING IT.

POSITIONING, HOOKUP, COMMISSIONING, TROUBLESHOOTING AND REPLACING POWER CABLES MUST ALWAYS BE DONE BY QUALIFIED PERSONS.

CHANGES IN THE POWER VOLTAGE OF MORE THAN 10% OF THE RATED VALUE CAN DAMAGE THE ELECTRICAL CIRCUITS; MONITOR THE MAINS VOLTAGE CONSTANTLY.

THE APPLIANCE MUST BE GROUNDED AS REQUIRED BY ELECTRICAL EQUIPMENT SAFETY STANDARDS.

THIS UNIT IS INTENDED ONLY FOR THE INTENDED PURPOSE OF TREATING WATER FOR TECHNICAL PURPOSES.

SHIPPING/DELIVERY:

THERE ARE NO SPECIAL PRECAUTIONS FOR UNPACKING THE APPLIANCE, EXCEPT FOR THE NORMAL CARE REQUIRED IN HANDLING FRAGILE MATERIALS. BEFORE DISPOSING OF THE PACKAGING, MAKE SURE IT DOES NOT CONTAIN ANY PARTS, INSTRUCTION BOOKLET OR OTHER DOCUMENTATION.

THE PACKAGING (CARDBOARD, EXPANDED POLYSTYRENE, PALLET, ETC.) MUST NOT BE LEFT WITHIN THE REACH OF CHILDREN, SINCE THEY ARE HAZARDOUS MATERIALS.

THE OSMOSIS TREATMENT UNIT MAY BE REMOVED FROM ITS ORIGINAL POSITION ONLY BY SPECIALISED PERSONS.

WHEN CLEANING THE APPLIANCE DO NOT USE CORROSIVE PRODUCTS, ACIDS, STEEL PADS OR BRUSHES.

DO NOT WASH THE APPLIANCE WITH DIRECT OR HIGH PRESSURE JETS OF WATER.

THE MANUFACTURER DECLINES ALL LIABILITY FOR INJURY/DAMAGE TO PERSONS OR PROPERTY CAUSED BY NON-OBSERVANCEOF THE INSTRUCTIONS GIVEN IN THIS MANUAL, INCORRECT USE, TAMPERING BY UNQUALIFIED PERSONS, TAMPERING WITH EVEN ONE PART OF THE APPLIANCE, OR THE USE OF NON-ORIGINAL SPARE PARTS, OR MODIFICATIONS, ACCESSORIES OR DEVICES OF ANY KIND APPLIED TO THE APPLIANCE UNLESS EXPRESSLY SPECIFIED IN THIS MANUAL.

- 30 -

Image 4
Contents WO-01 Page Contents General warnings Technical characteristics 150-600 KPa Bar Electrical hookup PositioningPlumbing hookup Page Pressurizing and starting up the unit Delivery pump startup first startupReplacing the pre-filter Replacing the membranesSpecial adjustments InactivityPlumbing diagram FIL Wiring diagram Hook UP J2 Green Power LED RES List of faults Osmosis-treated water not produced Water production not conforming Page Electronic circuit board and programming Page