Agilent Technologies FS2343 user manual Default Trigger

Page 16

TID – single Transaction identifier bit, used in Write Config. Register Channel Command.

SD - Status delay, 2 bit field used in Sync command. Allows return status data to be delayed by up to 3 frames.

EL0s - The EL0s bit indicates the channel should transition from the L0 state to the L0s state for exactly 42 frames. The L0 state is the state when the channel is ready to accept Channel and DRAM commands. The L0s state is an optional state used in systems that use power management.

ERC - The ERC bit indicates that the channel should transition from L0 state to recalibrate state for exactly 42 frames. Used in Sync frame.

IER – This bit indicates that commands and CRC errors be ignored by the AMB until after the next reset. Used in Sync frame.

A10:2 - Address bus for Read or Write configuration Channel Commands.

Default Trigger

When a configuration file is loaded the default trigger will be set to trigger the analyzer when the Mode bit is = 0 and Frame = 1. When mode and frame are set at these values the AMB will be done with training sequences and the data that is on the channel is properly aligned and can be decoded properly by the decoder.

16

Image 16
Contents Fbdimm Interposer Probe FS2343 Product Warranty Symbols For Technical Support For Sales and Marketing SupportAssistance Limitation of warrantyExclusive Remedies Software License Agreement Introduction Probe Performance LimitationDefinitions Logic Analyzer ModulesFS2343 Probe Description Probe Technical Feature Summary Probe ComponentsProbe overview Probe Set-upMechanical Brackets External Power supply Signal Assignments on Probe Pods Configuration filesLogic Analyzer card requirements Software Requirements Setting up the 169xx Analyzer169xx Licensing Page Configuration File Labels Channel Command labelsSampling labels Dram labelsDefault Trigger Symbols Dram commands A, B, C labels Symbol Symbol ValueChannel Commands A, B, C labels Symbol Symbol Value Preferences Below is a picture of the preference options Probe Settings Paddle card SettingsSM SMBus Control Using the Probe Control Software Probe Control ApplicationEvent Bus Cabling Loading the Probe Control SoftwareSetup SB Commands Store Qualification Trigger Events Event Bus Setting Sample Positions State Analysis OperationPage Offline Analysis State DisplayPage Page J9 Pods 1Odd and 2 Even AppendixCLK J11 Pods 1Odd and 2 Even SDA SCLSamtec J15 Pod 1Odd TRIGGER1 J12 Pods 1Odd and 2 Even TRIGGER7TRIGGER4 J10 Pods 1Odd and 2 Even Ground Anlyclk1n Odd DP16N/Odd Even DP16N/Even J13 Pods 1Odd and 2 Even TRIGGER3 General Information