Agilent Technologies FS2343 user manual Probe Control Application, Event Bus Cabling

Page 22

Event Bus Cabling

The Event Bus bits, Evbus[0:3], from other probes can be daisy chained across multiple probes in order to provide cross probe control of other probes. There are 2 EV cable connectors on each probe and both connectors are wired in parallel so that either can be used. Additionally, the probe has termination sensing circuitry so that the Evbus[0:3] signals are properly terminated on the probe if the cables are not used.

The cables are connected at either J9 or J10 on the board with their wires exiting the board from the top. LED D1 will light if the cables are attached backwards.

Probe Control Application

The FS2343 Interposer probe is controlled from a Probe Add-in, which has to be installed on the 16900 workspace as it communicates through the logic analyzer cards through an internal SM (SMBus) port which is connected to the probe by means of the adapter cable connection.

Loading the Probe Control Software

Load the CD provided with the probe into the 16900 frame and locate the file FBD Probe Control.exe. Double-click this file and it will install and be available in the Agilent Logic analyzer software under the Setup tab as the FBDIMM Probe.

Using the Probe Control Software

Always use the “Apply” button before changing windows or using the “OK” button. It is important to note that the probe control software sets up registers within the AMB. It is still necessary to set up parameters in the configuration file for triggers, storing, filtering etc. Setting up the AMB through the probe control software generates signals going to the logic analyzer, the logic analyzer can then use these signals to qualify, trigger or filter events or data of interest.

Please see the following pages for details for the different register settings within the AMB.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Fbdimm Interposer Probe FS2343 Product Warranty Symbols For Technical Support For Sales and Marketing SupportAssistance Limitation of warrantyExclusive Remedies Software License Agreement Definitions IntroductionProbe Performance Limitation Logic Analyzer ModulesFS2343 Probe Description Probe Technical Feature Summary Probe ComponentsProbe overview Probe Set-upMechanical Brackets External Power supply Signal Assignments on Probe Pods Configuration filesLogic Analyzer card requirements Software Requirements Setting up the 169xx Analyzer169xx Licensing Page Sampling labels Configuration File LabelsChannel Command labels Dram labelsDefault Trigger Symbols Dram commands A, B, C labels Symbol Symbol ValueChannel Commands A, B, C labels Symbol Symbol Value Preferences Below is a picture of the preference options Probe Settings Paddle card SettingsSM SMBus Control Event Bus Cabling Using the Probe Control SoftwareProbe Control Application Loading the Probe Control SoftwareSetup SB Commands Store Qualification Trigger Events Event Bus Setting Sample Positions State Analysis OperationPage Offline Analysis State DisplayPage Page J9 Pods 1Odd and 2 Even AppendixCLK J11 Pods 1Odd and 2 Even SDA SCLSamtec J15 Pod 1Odd TRIGGER1 J12 Pods 1Odd and 2 Even TRIGGER7TRIGGER4 J10 Pods 1Odd and 2 Even Ground Anlyclk1n Odd DP16N/Odd Even DP16N/Even J13 Pods 1Odd and 2 Even TRIGGER3 General Information
Top Page Image Contents