Agilent Technologies FS2343 user manual SM SMBus Control, Paddle card Settings, Probe Settings

Page 21

SM (SMBus) Control

Paddle card Settings

The FS2343 probe is designed so that AMB/LAI device control can be either from the 16900 logic analyzer and the Probe Control application software resident there, or from another FS2343 probe (slave mode).

This feature is controlled by means of a 6 position switch on the probe paddle card near the logic analyzer connections.

The factory configuration is for 16900 control of the probe. The settings on the switch are dependent on the configuration file used. The following picture shows the jumper and switch configurations on the paddle card.

Config file	SW# ON, all others off
FB238_1	1 and 4
FB238_2	1 and 4
FB238_3	3 and 6
FB238_4	1 and 4

Probe Settings

There is a 4 position jumper location at U8 on the top side of the FS2343 Interposer probe. There are jumpers that can be placed over each of the 4 set of pins. They have the following function:

5	8

1	4

Jumper	Function

1 - 5	Probe ID bit 0 Address 20

2 - 6	Probe ID bit 1 Address 21

3 - 7	Jumper removed = AMB SMBus
	connected to analyzer at powerup.
	Factory config – installed
	Jumper installed = AMB SMBus
	connected to motherboard at power
	up.

4 - 8	Unused

21

Image 21

Contents Fbdimm Interposer Probe FS2343 Product Warranty Symbols For Sales and Marketing Support For Technical SupportLimitation of warranty AssistanceExclusive Remedies Software License Agreement Probe Performance Limitation IntroductionDefinitions Logic Analyzer ModulesFS2343 Probe Description Probe Components Probe Technical Feature SummaryProbe Set-up Probe overviewMechanical Brackets External Power supply Configuration files Signal Assignments on Probe PodsLogic Analyzer card requirements Setting up the 169xx Analyzer Software Requirements169xx Licensing Page Channel Command labels Configuration File LabelsSampling labels Dram labelsDefault Trigger Dram commands A, B, C labels Symbol Symbol Value SymbolsChannel Commands A, B, C labels Symbol Symbol Value Preferences Below is a picture of the preference options Paddle card Settings Probe SettingsSM SMBus Control Probe Control Application Using the Probe Control SoftwareEvent Bus Cabling Loading the Probe Control SoftwareSetup SB Commands Store Qualification Trigger Events Event Bus State Analysis Operation Setting Sample PositionsPage State Display Offline AnalysisPage Page Appendix J9 Pods 1Odd and 2 EvenCLK SDA SCL J11 Pods 1Odd and 2 EvenSamtec J15 Pod 1Odd TRIGGER1 TRIGGER7 J12 Pods 1Odd and 2 EvenTRIGGER4 J10 Pods 1Odd and 2 Even Ground Anlyclk1n Odd DP16N/Odd Even DP16N/Even J13 Pods 1Odd and 2 Even TRIGGER3 General Information