Shark S3101W, S3101C Operating Instructions Caractéristiques, How To Assemble Your Steam Mop

MAX

Fig. 3

5

OPERATING INSTRUCTIONS

CARACTÉRISTIQUES

How To Assemble Your Steam Mop

1.Remove all the parts from the packaging.

2.Insert the upper extension tube into the lower extension tube. (Fig. 1) Push it in until you

hear it click into place.

3.Insert the extension tube assembly into the pump actuator. Make sure that the locking tab snaps into place.

(Fig. 1)		Pump
4. Place the micro-fiber		actuator
cleaning pad
underneath the
mop head. Make
sure that the hook
and latch strips are
facing up. (Fig. 2)		Fig. 1
Press to secure.
TIP: The micro-fiber
cleaning pads have
a colored tab so that		Mop
a different pad can		head
be assigned to
different tasks or
rooms in the	Hook & latch
house.	strips

Fig. 2

Filling the Water Tank IMPORTANT: Always insure that the unit is “UNPLUGGED” from the wall receptacle prior to filling and before attaching the micro-fiber cleaning pad to the bottom of the mop head. Never use the steam mop without the micro-fiber cleaning pad attached to the mop head. NOTE: When using your new steam mop for the first time you may notice water residue inside of the unit. Water drops can also be found in the packaging. This is normal and you should not be alarmed. Each steam mop is 100% tested in the factory to ensure product performance and safety. Sometimes

water is left in the unit from these test procedures. 1. Turn the cap

counter clockwise and then lift up to remove from the water tank. (Fig. 3)

2.Using the filling flask and funnel, pour one flask of water into the water tank. Do not overfill the unit past the “MAX” fill line on the water tank. (Fig. 3)

3.Replace the cap onto the water tank.

Using the Steam Mop

IMPORTANT: Never use the steam mop without the micro-fiber cleaning pad attached to the mop head or without water in the water tank.

Please note that when using for the first time, the appliance may take longer than the normal 30 second startup time to steam. You may need to pump the handle a few times before the steam is released. This is due to the water making its way from the water tank through the pump and into the heater. This will only occur during the first use.

1.Sweep or vacuum floors before using the steam mop.

2.Twist the quick release cord holder to unwrap the power cord completely.

3.Plug into a 120-volt electrical outlet.

4.The power “On” light will turn green.

5.It takes approximately 30 seconds for the unit to heat up and the steam to be ready.

6.Pump the handle a few times to dampen the micro-fiber cleaning pad. Begin mopping with a forward and backward motion, this pumping action will release steam as you mop.

7.When the water tank is empty, the steam mop will stop emitting steam. Unplug the power cord from the electrical outlet and refill the water tank following the instructions above.

8.When you have finished using the steam mop, unplug the unit from the electrical outlet and carefully remove the micro-fiber cleaning pad from the mop head. Please note that the micro- fiber cleaning pad gets very hot with the steam. Always use caution when removing.

9.Never leave the micro-fiber cleaning pad on the steam mop head when you have finished using the steam mop.

Votre vadrouille à vapeur Shark utilise la vapeur pour éliminer la graisse, la saleté et les dépôts tenaces. La vapeur est le nettoyant naturel le plus pur et le plus puissant. Elle permet de nettoyer les surfaces dures en sécurité à la maison, sans produit chimique corrosif. Elle est entièrement écologique. Elle nettoie vos planchers de tuile, de bois, de linoléum et de plastique vinylique.

1.Rapide et facile

Élimine le rinçage, le tordage, le transport de seaux d'eau et la redistribution de la saleté sur les planchers.

2.Puissante

Séchage rapide contrairement aux vadrouilles conventionnelles. Utilise une vapeur puissante pour un nettoyage et une hygiène supérieure.

3.Aucun produit chimique

Utilisez l'eau du robinet ou de l'eau distillée. Ne laisse aucun résidu chimique.

4.Légère

Aucun seau lourd à transporter. La vadrouille à vapeur Shark ne pèse que 1.5 kg. Seulement le tiers du poids d’un seau d’eau et d’une vadrouille conventionnelle.

5.Ergonomique

Poignée ergonomique à prise facile. Sa conception confortable facilite la manœuvre sans effort physique.

6.Démarrage rapide


La vapeur est prête en seulement 30 secondes.

7. Témoin d’alimentation

Le témoin d'alimentation s’illumine en vert une fois l'appareil branché.

8.Chiffon de nettoyage réutilisable

Le chiffon de microfibre à triple couche durable dégage, soulève et absorbe la saleté. Vous n’avez ensuite qu’a mettre dans la laveuse.

22