Invacare Excelerator XLT 2000 manual Back/Seat, C K A T, Excelerator/Lil Excelerator Figure

BACK/SEAT PROCEDURE 9

This Procedure includes the following:

Back Height Adjustment (Adjustable Backs Only) Sliding Seat Adjustment

Excelerator XLT/XLT 2000 Back Angle Adjustment

WARNING

After ANY adjustments, repair or service and BE- FOREuse,makesureallattachinghardwareistight- ened securely - otherwise injury or damage may result.

BACK HEIGHT ADJUSTMENT (ADJUSTABLE BACKS ONLY) (FIGURE 1)

1.Unlatch the two (2) fastening flaps that secure the top of the back upholstery to the back canes.

WARNING

PushpinMUSTprotrudethroughholein backcane.

Ensurethatbothbackcaneinsertsareatthesame height BEFORE reassembling the chair.

2.Press the push pin on the back cane insert tube in and adjust the back height to one (1) of three (3) heights depending on original back height.

3.Reinstall the fastening flaps onto the back canes, en- suring the fastening strips face towards the front of the Excelerator.

NOTE: The fastening flap with the Invacare logo is for the left back cane.

Top of Back

Upholstery

Fastening Flaps

Back Canes

Back

Cane

Insert

Push

Pin

FIGURE 1 - BACK HEIGHT ADJUSTMENT

(ADJUSTABLE BACKS ONLY)

4.Secure the top of the back upholstery to the fastening flaps ensuring the top of the back upholstery is even with the top of the back canes.

SLIDING SEAT ADJUSTMENT (FIGURES 2 AND 3)

Excelerator/Li'l Excelerator (FIGURE 2)

NOTE: The seat is supported on adjustment rails to allow forward/rearward adjustment. The adjustment lever is located on the underside of the seat, at the front left.

1.Activate parking brake.

2.Grasp forward/rearward adjustment lever and push it to the right and slide seat forward or rearward.

3.Ensure that seat is properly engaged into the seating position you desire by "jiggling" the seat, making sure that the seat engages into the locking notch and ad- justment lever returns to its original forward facing position.

NOTE: User need not be in seat to slide seat forward or rearward.

REPLACEMENT.

1.Remove the locknuts, bolts, and coved spacers from both sliding seat rail brackets.

2.Remove sliding seat and seat rails from brackets.

Seat	Adjustment Lever
Back

Seat Rails

Seat Rail

Locknuts

and

Threaded

Studs (Both

Sides)

Seat Rail Bracket Locknuts, Bolts, and

Coved Spacers (Both Sides)

FIGURE 2 - SLIDING SEAT ADJUSTMENT -

EXCELERATROR/LI'L EXCELERATOR

B A C K

/

S E A T

23