Invacare Excelerator XLT 2000, Li'l Execelerator manual Footrest, Leg Guard

FOOTREST PROCEDURE 11

EXCELERATOR XLT/XLT 2000 FOOTREST AND LEG GUARD REPLACEMENT (FIGURE 2)

Footrest

1.Note the position of the existing footrest.

2.Remove the hex bolt and locknut that secure the ex- isting footrest to the fork.

3.Remove the existing footrest from the clamp on the fork.

4.Slide the new footrest into the clamp on the fork to the position noted in STEP 1.

5.Reinstall the hex bolt and locknut. Tighten securely.

6.Repeat STEPS 1-5 for the opposite footrest, if nec- essary.

Leg Guard

1.Loosen the two (2) allen screws on each mount- ing clamp.

Footrest Replacement

Fork

Clamp,

Hex Bolt

and

Locknut

Footrest

Leg Guard Replacement

F O O T R E S T

2.	Position each mounting clamp onto the fork under		Fork
	the brake cable as shown in FIGURE 2.
NOTE: The leg guard should surround, but not touch			Brake
the REAR of the front tire.
3.	Tighten the two (2) allen screws on each mounting		Cable
	clamp securely.	Rear of
		Front	Allen
		Tire	Screws

Mounting

Clamp

Leg Guard

FIGURE 2 - EXCELERATOR XLT/XLT 2000 FOOTREST

AND LEG GUARD REPLACEMENT

27