Invacare IISTANDARD, IIJR, IIBASIC, II250 SERIES manual REMOVING/INSTALLING Shrouds, R O U D S

PROCEDURE 9 SHROUDS

S H R O U D S

This Procedure Includes the Following:

Removing/Installing Shrouds

WARNING

After ANY adjustments, repair or service and BE- FORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

REMOVING/INSTALLING SHROUDS

MWD Wheelchairs (FIGURE 1)

REMOVING FRONT SHROUD.

1.Turn the two (2) 1/4-turn bolts that secure front shroud to the two (2) side shrouds COUNTERCLOCKWISE.

2.Remove the front shroud from the wheelchair.

INSTALLING FRONT SHROUD.

1.Positionthetwo(2)1/4-turnboltswiththetwo(2)mount- ing holes in the side shrouds.

2.Install the front shroud onto the two (2) side shrouds.

3.Turn the two (2) 1/4-turn bolts that secure the front shroud to the two (2) side shrouds CLOCKWISE.

REMOVING REAR SHROUD AND REAR STORAGE COMPARTMENT.

1.Lift up on rear shroud and remove from wheelchair.

2.Turn the two (2) 1/4-turn bolts that secure the rear stor- agecompartmenttothewheelchairframeCOUNTER-

CLOCKWISE.

3.Remove rear storage compartment from wheelchair.

INSTALLING REAR SHROUD AND REAR STORAGE COMPARTMENT.

1.Positionthetwo(2)1/4-turnboltswiththetwo(2)mount- ing holes in the wheelchair frame.

2.Install rear storage compartment onto chair frame.

3.Turn two (2) 1/4-turn bolts that secure the rear storage compartment to the wheelchair frame CLOCKWISE.

4.Position rear shroud on the two (2) side shrouds and slide towards the front of the wheelchair until it stops.

5.Press down on the rear shroud until the two (2) clips secure the rear shroud to the two (2) side shrouds.

38