Invacare II250 SERIES, IIJR, IIBASIC Joystick Cable, Rear Battery, ALL Models Except Ranger Iijr

Page 51

FWD WHEELCHAIRS

PROCEDURE 11

 

 

 

8.Feed the retaining strap through the slot located on the top of the rear shroud.

9.Bundle excess joystick cable and tie wrap together. See DETAIL "A".

10.Positionbundledjoystickcablebetweenretainingstrap and rear battery box. See DETAIL "A".

11.Clip the retaining strap together to secure the rear shroud and battery box in place.

12.Press down on the rear shroud until the two (2) clips secure the rear shroud to the two side shrouds.

13.Connect the battery leads from the battery boxes to the battery connectors on the wheelchair frame.

14.If necessary, install the Captain's Seat. Refer to RE- MOVING/INSTALLINGCAPTAIN'SSEATinPROCE- DURE 5 of this manual.

15.If necessary, reinstall the removeable footboard. Refer to PREPARING THE REMOVEABLE FOOTBOARD FOR WHEELCHAIR TRANSPOR- TATION in PROCEDURE 3 of this manual.

Joystick Cable

DETAIL "A"

 

 

Rear Battery

 

Box

Tie-Wrap Retaining

Strap

Retaining

Retaining

Strap

Strap Clip

Rear

Front

Battery

Battery Box

Box

 

Battery

Front of the

Wheelchair

Tray

 

Battery Connections on

 

Side of Wheelchair Frame

 

NOTE: Wheelchair Frame not shown for clarity.

FIGURE 5 - INSTALLING/REMOVING BATTERY BOXES

ALL MODELS EXCEPT RANGER IIJR

RANGER IIJR (FIGURE 6).

1.Verify that the ON/OFF switch on the joystick is in the OFF position.

2.If necessary, remove the front and rear shrouds. Refer to REMOVING/INSTALLING SHROUDSin PROCE- DURE 9 of this manual.

NOTE: Make sure the battery cables on the battery boxes are on the same side as the battery connectors on the wheelchair frame.

WARNING

The battery connector on the front battery box MUST be connected to the wiring harness be- fore placing front battery on battery tray. Oth- erwise, injury may result.

3.Connect the battery cables from the front battery box to the battery connectors on the wheelchair frame.

4.Position the front battery box onto the battery tray as shown in FIGURE 6.

5.Feed the front retaining strap through the slot located on the top of the front shroud.

6.Position the bottom of the front shroud in-between the front battery box and edge of battery tray.

7.Clip the front retaining strap together.

8.Pull end of retaining strap to secure front battery box and front shroud in place.

9.Position the rear battery box onto the battery tray as shown in FIGURE 6.

10.Connect the battery cable from the rear battery box to the rear battery connectors on the wheelchair frame.

11.Bundle excess joystick cable and tie wrap together. See DETAIL "A".

12.Position excess joystick cable between retaining strap and rear battery box. See DETAIL "A".

13.Clip the rear retaining strap together.

14.Pull end of retaining strap to secure battery box and joystick in place.

15.Installtherearshroud.Referto REMOVING/INSTALL- ING SHROUDS in PROCEDURE 9 of this manual.

16.If necessary, reinstall the removeable footboard. Refer to PREPARING THE REMOVEABLE FOOTBOARD FOR WHEELCHAIR TRANSPOR- TATION in PROCEDURE 3 of this manual.

F

W D

W H E E L C H A I R S

51

Page 50 Page 52
Image 51
Page 50 Page 52
Contents MWD/FWD Wheelchair TIE-DOWN Restraints and Seat Positioning Straps R N I N GTable of Contents Specification S Integrated Sling Seat CaptainsseatPerformance Electronics SpecificationsRain and operators weight PerformanceIntegrated Sling Seat Procedure 1 of this manualGeneral Guidelines ProcedureGeneral Guidelines ProcedureCoping With Everyday Obstacles SAFETY/HANDLING WheelchairsStability and Balance StairwaysRII FWD Model Wheelchairs only Figure Shift body weight into seat with transferMinimize GAP Distance RII MWD Wheelchairs onlyReaching, Leaning, Bending and Bending Forward Functional Reach From a WheelchairReaching, Bending Backward General Guidelines Push Bracket CrossbraceRanger II BASIC/RANGER II STANDARD/RANGER II 250 Series General GuidelinesprocedureBack View Motor Assembly BatterySide Frame Controller Part numberShipping Insert Installed Shipping Insert Battery BoxShipping Insert Removed Safety INSPECTION/TROUBLESHOOTING Troubleshooting MechanicalTroubleshooting Electrical Checking Battery Charge LevelNumber of Floating Balls Will Vary According to Charge Safety INSPECTION/TROUBLESHOOTINGUsing Hydrometer to Check Battery Cells Lead Acid Figure Number of Floating BallsArms Procedure Safety Inspection ChecklistO N T I N G S INSTALLING/REMOVING Footrests FigureAdjusting Footrest Height Front RiggingsModel Footrests Procedure Front RiggingsP93M Model Footrests Figure Lug Bolt Footrest Support Locknut LowerAdjusting Calfpads AdjustingRaising/Lowering Elevating Legrests Depth All Models Figure Adjusting Removable FootboardAdjusting Footboard Angle ALL Models Figure ReplacingFront Hex ScrewFootboard Pivot Caplug Assemblies Washer Battery TrayRemoving The Removable Footboard Plate Installing The Removable Footboard PlateM S INSTALLING/REMOVING Flip Back Armrests FigureAdjusting Flip Back Armrests Figure ArmsHeight Figure Adjusting Captains Seat ArmrestsProcedure Arms Positioning Flip Back Armrests for UseH O L S T E R Y P T a I N S A T Adjusting Captains Seat FigureReplacing Seat Upholstery Figure UPHOLSTERY/CAPTAINS SEAT/POSITIONING StrapIntegrated Sling Seat Models Figure REMOVING/INSTALLING Captains Seat FigureReplacing Seat Positioning Strap UPHOLSTERY/CAPTAINS SEAT/POSITIONING StrapElectronics Mkiv Joystick Adjustment JoystickLock MountingTubePreparing Mkiv Joystick for USE Figure Repositioning Mkiv JoystickSwitch ElectronicsPerform one 1 of the following Battery FuseWiringHarness Holder Fuse ReplacementAll MWD Models and FWD Model Ranger Iijr Figure Replacing Battery BOX Retaining StrapT a I N I N G Retaining StrapAll FWD Models Except Ranger Iijr Figure Hex Bolt Battery Tray Tray Support LocknutRetaining Strap T a I N I N G R a POutside of Wheelchair Front of Wheelchair ENGAGING/DISENGAGING Motors with Motor Locks FigureE E L S WheelsDust Cover Locknut Nylon Washer Caster Headtube Fork Adjusting Forks FigureWheels Remove the dust cover from the caster headtubeREMOVING/INSTALLING Shrouds R O U D SShrouds Shrouds REMOVING/INSTALLING Shrouds MWD WheelchairsInstalling Rear Shroud FWD Wheelchairs FigureRemoving Rear Shroud Battery Box Rear Shroud Inch wide chairs ClipClip Retaining Strap Batteries T T E R I E SDual U1 Batteries Connecting Battery CablesBatteries Direct Mount Method , 3Connect Battery Cable to Battery Terminal AS Shown Connect Battery Cables Ring Terminals to This Side PostsInstalling Battery Clamp Covers Battery Clamp Method Figures 4, 5Fuse Box RED Battery Clamp CoverNegative Battery Terminal/Post Tie-Wrap Group 22NF Battery E R I E SUnfolding Transporting Ranger II FWDFWD Wheelchairs E E L C H a I R SMCC-MKIV X, a or A+ Joystick When to Charge Batteries FigureFWD Wheelchairs Mkiv RII JoystickReplacing Batteries Description and Use of Battery ChargersShutoff Procedure Charging Batteries FigureINSTALLING/REMOVING Battery Boxes Recommended Battery TypesCleaning Battery Terminals Ranger Iijr Figure Rear BatteryJoystick Cable ALL Models Except Ranger IijrUnfolding Battery Tray for Use Figure Battery TrayProcedure 11FWD Wheelchairs Folding Battery Tray for Transport FigureRanger Iibasic and Ranger Iistandard Pins Pivot Battery TrayNotch Battery Tray Hanger Bracket Pins Mounting Battery Tray SlotsUnfolding/Folding Integrated Sling Seats Figure Transporting Ranger II MWDE E L C H a I R MWD WheelchairsPush Brackets Crossbraces Battery Discharge Indicator BDI Battery Gauge Display BGDMWD Wheelchairs Refer to DisconnectA I R S Prong plug, 15 ampere current rating industrial typeIf necessary, remove the rear shroud. Refer to RE Detail a INSTALLING/REMOVING Battery Boxes Figure Retaining Front Battery Box Strap Rear Strap ClipLeads Installing Battery Tray Adjusting the Stabilizer FigureBattery Tray Figure Additional Adjustments for User Preference Detail BLimited Warranty
Top Page Image Contents