FRONT RIGGINGS | PROCEDURE 3 |
This Procedure includes the following:
Installing/Removing the Footrest(s)
Adjusting the Footrest Height
Installing/Adjusting Adjustable Angle
Impact Guards/Optional Calf Strap
Heel Loop Replacement
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attachment hardware is tightened securely - other- wise, injury or damage may result.
INSTALLING/REMOVING THE FOOTREST(S) (FIGURE 1)
NOTE: Remove the footrests from the wheelchair by re- versing this procedure.
1.Turn the footrest to the side (open footplate is perpen- dicular to wheelchair).
2.Insert footrest mounting pin into mounting tube.
3.Push the footrest towards the inside of the wheel- chair until it locks into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4.Repeat this procedure for other footrest assembly.
5.To release the footrest, push the footrest release le- ver inward, rotate footrest outward.
ADJUSTING THE FOOTREST HEIGHT (FIGURE 2)
NOTE: Lay the assembly on a flat surface to simplify this procedure.
1.Remove the footrest from the wheelchair. Refer to INSTALLING/REMOVINGTHEFOOTREST(S)inthis procedure of the manual.
2.Remove impact guards and/or calf strap, if necessary.
3.Remove the hex screw and coved washer and posi- tion the footrest assembly to a determined height.
4.Lineup the mounting hole in the footrest frame, rein- sert the hex screw and coved washer;
5.Tighten the hex screw and coved washer to
6.Repeat this procedure for the other footrest.
7.Replace impact guards and/or calf strap, if necessary.
Coved Washer
Hex Screw
Footrest
FIGURE 2 - ADJUSTING THE FOOTREST HEIGHT
F R O N T
R
I
G G I N G S
Footrest
Mounting
Pin
Footrest Release
Lever
Mounting
Tube
INSIDE OF
WHEELCHAIR
Footrest
OUTSIDE
OF
WHEELCHAIR
INSTALLING/ADJUSTING ADJUSTABLE ANGLE FLIP-UP FOOTPLATES
WARNING
When determining the angle of the footplates, make sure the rear of the footplates DO NOT interfere with the move- ment of the front casters.
Installing Hinge (FIGURE 3)
FIGURE 1 - INSTALLING/REMOVING THE
FOOTREST(S)
NOTE: This procedure is for individual adjustable angle footrests only.
1.
2.Positionthehardwareonthefootrestsupportasshown in FIGURE 3.
15