REAR WHEELS | PROCEDURE 7 |
INSTALLING QUAD-RELEASE AXLES (FIGURE 3)
1.Remove rear wheel and the existing
2.
3.Insert new
4.Slide locking collar onto
5.Reinstall rear wheel and the
WARNING
Make sure the detent pin and detent balls of the
Keep detent balls clean.
6.Flip handle of
7.If detent pin does not fully release, proceed to AD-
JUSTING THE
8.Repeat STEPS
Allen | Axle | ||
Axle | |||
Screw | Mounting | ||
| |||
|
| Plate | |
| Locking Collar | ||
Rear Wheel Hub
FIGURE 3 - INSTALLING QUAD-RELEASE AXLES
ADJUSTING QUAD-RELEASE HANDLES
In and/or Out (FIGURE 4)
1.Remove rear wheel and the
2.Loosen the locking screw.
3.Make the following adjustments:
If the
CLOCKWISE.
If the
COUNTERCLOCKWISE.
4.Tighten the locking screw.
5.Reinstall the rear wheel and
WARNING
Make sure the detent pin and locking pins of the
Keep detent balls clean.
6.Flip the handle of the
7.Repeat the above procedures until the
Detent Balls
Handle
Axle Mounting Plate
Locking Screw
FIGURE 4 - ADJUSTING QUAD-RELEASE
HANDLE IN/AND OR OUT
Removing the Play From the Rear Wheels (FIGURE 5)
NOTE: The adjusting nut on the
1.
Tighten the length adjusting screw until there is no in and out movement of the
Quad Release
Axle
Length Adjustment Screw 
FIGURE 5 - REMOVING PLAY FROM THE
REAR WHEELS
R E A R
W
H
E
E
L
S
27