FRONT RIGGINGS | PROCEDURE 3 |
Perpendicular and/or Inversion/Eversion Adjustment (FIGURES 4 AND 6)
NOTE: It is not necessary to remove the footplate to per- form this adjustment.
1.Insert a flathead screwdriver through the half clamp on the articulating footplate.
2.Slowly turn the nylon adjustment screw in or out until the articulating footplate is perpendicular to the foot- rest assembly or the desired inversion or eversion is obtained.
Footrest Support FRONT VIEW OF FOOTPLATE AND
FOOTREST SUPPORT
Footplate
FIGURE 6 - PERPENDICULAR AND/OR INVERSION/EVERSION ADJUSTMENT
IMPACT GUARDS/OPTIONAL CALF STRAP (FIGURE 7)
1.Remove impact guard/calf strap from packaged con- tainer if not already secured to the footrest.
2.Secure the impact guards to the footrest frame as shown in FIGURE 7.
3.Secure the optional calf strap around the footrest frame (with the impact guards attached).
Calf
Strap
Impact
Guards
FIGURE 7 - IMPACT GUARDS/OPTIONAL
CALF STRAP
HEEL LOOP REPLACEMENT (FIGURE 8)
Composite Footplates
1.Remove the hex screw and coved washer that se- cures the lower half of the footrest to the swingaway footrest assembly.
2.Remove the lower footrest assembly.
3.Remove the phillips screw and locknut that secure the heel loop to the footrest.
4.Slide heel loop over slide tube of footrest assembly.
5.Replace heel loop.
6.Reverse preceding steps to reassemble.
NOTE: When securing the heel loop to the footrest as- sembly, tighten the phillips screw and locknut until the spacer is secure.
Adjustable Footplate
1.Remove the four (4) phillips screws and washers that secure the existing heel loop to the footplate.
2.Position the mounting holes of the new heel loop with the mounting holes in the adjustable footplate.
3.Secure the new heel loop to the footplate with the four
(4) phillips screws and washers.
COMPOSITE FOOTPLATES
Hex Screw/Coved Washer
Phillips Screw
Spacer
Locknut
ADJUSTABLE FOOTPLATES
Phillips Screw
Washer
Washer 
Phillips Screw 
FIGURE 8 - HEEL LOOP REPLACEMENT
F R O N T
R
I
G G I N G S
17