Motorola XTNID manual Getting Started Radio LED Indicators, Radio Status LED Indication

Page 32

GETTING STARTED

RADIO LED INDICATORS

	RADIO STATUS	LED INDICATION

	Channel Alias Edit	Red heartbeat

	Channel Busy	Solid orange
	Cloning Mode	Two orange heartbeats

	Cloning In Progress	Solid orange
	Fatal Error at Power up	One green blink, one orange blink, one green blink, then repeat for
	Fatal Error at Power up	4 seconds
		4 seconds

	Low Battery	Orange blink
	Low Battery Shutdown	Orange heartbeat

	Monitor	LED is OFF
	Power-Up	Solid red for 2 seconds

	‘Idle’ Programming Mode /	Green heartbeat
	Channel Mode	Green heartbeat
	Channel Mode

	Scan Mode	Red heartbeat)

	Transmit (Tx)/Receive (RX)	Red heartbeat

Note: Channel Alias Edit only applies to Display Models

English 30

Image 32

Contents Page Page Contents Programming Features Getting StartedAccessories ContentsComputer Software Copyrights Computer Software CopyrightsSafety SafetyBatteries and Chargers Safety Information Batteries and Chargers Safety InformationOperational Safety Guidelines Radio Radio OverviewParts of the Radio Radio Overview Lithium-Ion Li-Ion Battery Side ButtonsModel Frequency Transmit Power Number Antenna Band Battery Features and Charging Options About the Li-Ion BatteryBatteries and Chargers Batteries and ChargersBattery Recycling and Disposal Battery Latchbattery latch Slots Turn OFF the radio Batteries and Chargers Install Remove Power Supply, Adaptors and Drop-in Tray ChargerInstalling Spring Action Belt Clip Battery Life InformationFollowing chart summarizes battery life estimations Charging the Battery Charging with the Drop-in Tray Single Unit ChargerCharging a Stand-Alone Battery Charging a Standard Battery Adjustable bracket Standard High and Ultra High Capacity Charging a High Capacity Battery Drop-in Tray Charger LED Indicators Standard Charger LED IndicatorEstimated Charging Time MUC LED Indicator Adjusting Volume Getting StartedGetting Started Turning Radio ON/OFFReceiving a Call Selecting a ChannelTalking and Monitoring Signal Strength Indicator and Channel Busy Indicators Talk RangeGetting Started Getting Started Radio LED Indicators Radio Status LED IndicationWith Compatible VOX Accessories HANDS-FREE USE/VOXReset To Factory Defaults Hands Free without Accessories iVOXBattery Save Setting VOX/iVOX Sensitivity End of Transmission Tone Roger Beep ToneKeypad Beeps Menu OptionsSetting VOX / iVOX sensitivity IVOGetting StartedImic YES Programming Features Entering Programming ModeProgramming RX Reception Codes CTCSS/DPL Programming FeaturesProgramming RX Reception Frequencies RX BW Programming RX Reception BandwidthProgramming Scramble L Programming Maximum Number of ChannelsMA X CH Programming Call TonesProgramming Microphone Gain Level YES Programming Scan ListProgramming Buttons Editing Channel Alias Name Nuisance Channel Delete Bandwidth Select Time-Out TimerCPS Computer Programming Software Scramble Battery Type SettingCall Tones Programming Features Cloning Radios Cloning with a Multi-Unit Charger MUCTurn on the Target radio and place it Into one of the SUCs What to do if cloning fails Cloning Radios using the CPS Computer Programming Software Troubleshooting TroubleshootingDoes not come on Cannot activate VOX USE and Care USE and CareIf the radio is submerged in water Channel Radios PMR 446 Defaults Frequency and Code ChartsFrequency and Code Charts Ctcss DPL Codes 108 627 115 712 Warranty Warranty InformationWhat is not Covered by the Warranty Motorola LimitedMotorola Limited Warranty Accessories Chargers Page 6871663M05