Motorola XTNID manual Batteries and Chargers, Battery Features and Charging Options

Page 14

BATTERIES AND CHARGERS

BATTERIES AND CHARGERS

XTNi™ Series radios provide Lithium-Ion (Li- Ion) batteries that comes in different capacities that will define the battery life. It also offers the option to use Alkaline batteries.The radio comes equipped with a rapid charger.

BATTERY FEATURES AND CHARGING OPTIONS

About the Li-Ion Battery

The XTNi™ radio series come equipped with a rechargeable Li-Ion battery. This battery should be charged before initial use to ensure optimum capacity and performance.

Battery life is determined by several factors. Among the more critical are the regular overcharge of batteries and the average depth of discharge with each cycle. Typically, the greater the overcharge and the deeper the average discharge, the fewer cycles a battery will last. For example, a battery which is overcharged and discharged 100% several

English 12

times a day, lasts fewer cycles than a battery that receives less of an overcharge and is discharged to 50% per day. Further, a battery which receives minimal overcharging and averages only 25% discharge, lasts even longer.

Motorola batteries are designed specifically to be used with a Motorola charger and vice versa. Charging in non-Motorola equipment may lead to battery damage and void the battery warranty. The battery should be at about 77°F (25°C) (room temperature), whenever possible. Charging a cold battery (below 50° F [10°C]) may result in leakage of electrolyte and ultimately in failure of the battery. Charging a hot battery (above 95°F [35°C]) results in reduced discharge capacity, affecting the performance of the radio. Motorola rapid-rate battery chargers contain a temperature-sensing circuit to ensure that batteries are charged within the temperature limits stated above.

Image 14
Contents Page Page Contents Programming Features Getting StartedAccessories ContentsComputer Software Copyrights Computer Software CopyrightsSafety SafetyBatteries and Chargers Safety Information Batteries and Chargers Safety InformationOperational Safety Guidelines Radio Radio OverviewParts of the Radio Radio Overview Lithium-Ion Li-Ion Battery Side ButtonsModel Frequency Transmit Power Number Antenna Band Batteries and Chargers Battery Features and Charging OptionsAbout the Li-Ion Battery Batteries and ChargersBattery Recycling and Disposal Battery Latchbattery latch Slots Turn OFF the radio Batteries and Chargers Install Remove Power Supply, Adaptors and Drop-in Tray ChargerInstalling Spring Action Belt Clip Battery Life InformationFollowing chart summarizes battery life estimations Charging the Battery Charging with the Drop-in Tray Single Unit ChargerCharging a Stand-Alone Battery Charging a Standard Battery Adjustable bracket Standard High and Ultra High Capacity Charging a High Capacity Battery Drop-in Tray Charger LED Indicators Standard Charger LED IndicatorEstimated Charging Time MUC LED Indicator Getting Started Adjusting VolumeGetting Started Turning Radio ON/OFFReceiving a Call Selecting a ChannelTalking and Monitoring Signal Strength Indicator and Channel Busy Indicators Talk RangeGetting Started Getting Started Radio LED Indicators Radio Status LED IndicationWith Compatible VOX Accessories HANDS-FREE USE/VOXReset To Factory Defaults Hands Free without Accessories iVOXBattery Save Keypad Beeps Setting VOX/iVOX SensitivityEnd of Transmission Tone Roger Beep Tone Menu OptionsSetting VOX / iVOX sensitivity IVOGetting StartedImic YES Programming Features Entering Programming ModeProgramming RX Reception Codes CTCSS/DPL Programming FeaturesProgramming RX Reception Frequencies RX BW Programming RX Reception BandwidthProgramming Scramble L Programming Maximum Number of ChannelsMA X CH Programming Call TonesProgramming Microphone Gain Level YES Programming Scan ListProgramming Buttons Editing Channel Alias Name Nuisance Channel Delete Bandwidth Select Time-Out TimerCPS Computer Programming Software Scramble Battery Type SettingCall Tones Programming Features Cloning Radios Cloning with a Multi-Unit Charger MUCTurn on the Target radio and place it Into one of the SUCs What to do if cloning fails Cloning Radios using the CPS Computer Programming Software Troubleshooting TroubleshootingDoes not come on Cannot activate VOX USE and Care USE and CareIf the radio is submerged in water Channel Radios PMR 446 Defaults Frequency and Code ChartsFrequency and Code Charts Ctcss DPL Codes 108 627 115 712 What is not Covered by the Warranty WarrantyWarranty Information Motorola LimitedMotorola Limited Warranty Accessories Chargers Page 6871663M05