Motorola XTNID manual Hands-Free Use/Vox, With Compatible VOX Accessories

Page 33

HANDS-FREE USE/VOX

Motorola XTNi™ Series radios can operate hands-free (VOX) when used with compatible VOX accessories. A short delay occurs between when you start talking and the radio transmits.

With Compatible VOX Accessories

The default factory setting for VOX is OFF. In order to enable it, please make sure it is enabled by using the CPS (Computer Programming Software).

1.Turn radio OFF.

2.Open accessory cover.

3.Insert plug of audio accessory firmly into accessory jack.

4.Turn radio ON. Radio will beep and LED will blink double red. The display will show the

VOX icon.

5.Lower radio volume BEFORE placing accessory near ear.

6.To transmit, speak into accessory microphone and to receive, stop talking.

7.You can disable VOX operation by pressing M or removing the audio accessory.

Note: To order accessories, contact your Motorola dealer.

GETTING STARTED

31English

Image 33

Contents Page Page Contents Getting Started Programming FeaturesContents AccessoriesComputer Software Copyrights Computer Software CopyrightsSafety SafetyBatteries and Chargers Safety Information Batteries and Chargers Safety InformationOperational Safety Guidelines Radio Overview Parts of the RadioRadio Radio Overview Side Buttons Lithium-Ion Li-Ion BatteryModel Frequency Transmit Power Number Antenna Band About the Li-Ion Battery Battery Features and Charging OptionsBatteries and Chargers Batteries and ChargersBattery Recycling and Disposal Battery Latchbattery latch Slots Turn OFF the radio Batteries and Chargers Power Supply, Adaptors and Drop-in Tray Charger Install RemoveBattery Life Information Installing Spring Action Belt ClipFollowing chart summarizes battery life estimations Charging with the Drop-in Tray Single Unit Charger Charging the BatteryCharging a Stand-Alone Battery Charging a Standard Battery Adjustable bracket Standard High and Ultra High Capacity Charging a High Capacity Battery Standard Charger LED Indicator Drop-in Tray Charger LED IndicatorsEstimated Charging Time MUC LED Indicator Getting Started Adjusting VolumeGetting Started Turning Radio ON/OFFSelecting a Channel Talking and MonitoringReceiving a Call Talk Range Signal Strength Indicator and Channel Busy IndicatorsGetting Started Radio Status LED Indication Getting Started Radio LED IndicatorsHANDS-FREE USE/VOX With Compatible VOX AccessoriesHands Free without Accessories iVOX Battery SaveReset To Factory Defaults End of Transmission Tone Roger Beep Tone Setting VOX/iVOX SensitivityKeypad Beeps Menu OptionsIVO Setting VOX / iVOX sensitivityStarted GettingImic YES Entering Programming Mode Programming FeaturesProgramming Features Programming RX Reception FrequenciesProgramming RX Reception Codes CTCSS/DPL Programming RX Reception Bandwidth RX BWProgramming Maximum Number of Channels Programming Scramble LProgramming Call Tones MA X CHProgramming Microphone Gain Level Programming Scan List YESProgramming Buttons Editing Channel Alias Name Nuisance Channel Delete Time-Out Timer CPS Computer Programming SoftwareBandwidth Select Battery Type Setting Call TonesScramble Cloning with a Multi-Unit Charger MUC Programming Features Cloning RadiosTurn on the Target radio and place it Into one of the SUCs What to do if cloning fails Cloning Radios using the CPS Computer Programming Software Troubleshooting TroubleshootingDoes not come on Cannot activate VOX USE and Care If the radio is submerged in waterUSE and Care Frequency and Code Charts Frequency and Code ChartsChannel Radios PMR 446 Defaults Ctcss DPL Codes 108 627 115 712 Warranty Information WarrantyWhat is not Covered by the Warranty Motorola LimitedMotorola Limited Warranty Accessories Chargers Page 6871663M05