Motorola XTNID manual Installing Spring Action Belt Clip, Battery Life Information

Page 19

When acquiring additional chargers or power supplies, make sure you have similar drop-in tray chargers and power supplies set. For part number details refer to “Chargers” on page 65.

Installing Spring Action Belt Clip

belt clip tab

Spring

Action Belt

Clip

1.Slide the spring action belt clip rails into the belt clip grooves on the back of the battery pack and slide it down until the belt clip tab snaps into place.

2.To remove, pull back the metal release tab on the belt clip tab and push the spring action belt clip upward to remove.

Battery Life Information

Li-Ion Battery Life

Depending on the radio model and/or region the battery capacity will be different. This feature will determine the estimated battery life. When the Battery Save feature is ON (enabled by default) the battery life will be longer.

BATTERIES AND CHARGERS

17English

Image 19

Contents Page Page Contents Getting Started Programming FeaturesContents AccessoriesComputer Software Copyrights Computer Software CopyrightsSafety SafetyBatteries and Chargers Safety Information Batteries and Chargers Safety InformationOperational Safety Guidelines Parts of the Radio Radio OverviewRadio Radio Overview Side Buttons Lithium-Ion Li-Ion BatteryModel Frequency Transmit Power Number Antenna Band Batteries and Chargers Battery Features and Charging OptionsAbout the Li-Ion Battery Batteries and ChargersBattery Recycling and Disposal Battery Latchbattery latch Slots Turn OFF the radio Batteries and Chargers Power Supply, Adaptors and Drop-in Tray Charger Install RemoveBattery Life Information Installing Spring Action Belt ClipFollowing chart summarizes battery life estimations Charging with the Drop-in Tray Single Unit Charger Charging the BatteryCharging a Stand-Alone Battery Charging a Standard Battery Adjustable bracket Standard High and Ultra High Capacity Charging a High Capacity Battery Standard Charger LED Indicator Drop-in Tray Charger LED IndicatorsEstimated Charging Time MUC LED Indicator Turning Radio ON/OFF Adjusting VolumeGetting Started Getting StartedTalking and Monitoring Selecting a ChannelReceiving a Call Talk Range Signal Strength Indicator and Channel Busy IndicatorsGetting Started Radio Status LED Indication Getting Started Radio LED IndicatorsHANDS-FREE USE/VOX With Compatible VOX AccessoriesBattery Save Hands Free without Accessories iVOXReset To Factory Defaults Menu Options Setting VOX/iVOX SensitivityEnd of Transmission Tone Roger Beep Tone Keypad BeepsIVO Setting VOX / iVOX sensitivityStarted GettingImic YES Entering Programming Mode Programming FeaturesProgramming RX Reception Frequencies Programming FeaturesProgramming RX Reception Codes CTCSS/DPL Programming RX Reception Bandwidth RX BWProgramming Maximum Number of Channels Programming Scramble LProgramming Call Tones MA X CHProgramming Microphone Gain Level Programming Scan List YESProgramming Buttons Editing Channel Alias Name Nuisance Channel Delete CPS Computer Programming Software Time-Out TimerBandwidth Select Call Tones Battery Type SettingScramble Cloning with a Multi-Unit Charger MUC Programming Features Cloning RadiosTurn on the Target radio and place it Into one of the SUCs What to do if cloning fails Cloning Radios using the CPS Computer Programming Software Troubleshooting TroubleshootingDoes not come on Cannot activate VOX If the radio is submerged in water USE and CareUSE and Care Frequency and Code Charts Frequency and Code ChartsChannel Radios PMR 446 Defaults Ctcss DPL Codes 108 627 115 712 Motorola Limited WarrantyWarranty Information What is not Covered by the WarrantyMotorola Limited Warranty Accessories Chargers Page 6871663M05