Motorola XTNID manual Troubleshooting

Page 56

TROUBLESHOOTING

TROUBLESHOOTING

Symptom

Try this

 

Recharge or replace Li-Ion battery. Replace or reposition AA

No Power

batteries. Extreme operating temperatures affect battery life. Refer

 

to "About the Li-Ion Battery" on page 12.

 

 

Hearing other noises or

Confirm Interference Eliminator Code is set. Frequency or

Interference Eliminator Code may be in use. Change Code on all

conversation on a channel

radios if possible.

 

Message Scrambled

Scramble Code might be ON, and/or setting does not match other

radios' settings. Refer to "Programming Scramble L" on page 41.

 

 

 

 

Steel and/or concrete structures, heavy foliage, buildings or

 

vehicles decrease range. Check for clear line of sight to improve

Limited talk range

transmission. Wearing radio close to body such as in a pocket or on

 

a belt decreases range. Change location of radio. Refer to "Talking

 

and Monitoring" on page 27.

 

 

English 54

Image 56
Contents Page Page Contents Programming Features Getting StartedAccessories ContentsComputer Software Copyrights Computer Software CopyrightsSafety SafetyBatteries and Chargers Safety Information Batteries and Chargers Safety InformationOperational Safety Guidelines Radio Radio OverviewParts of the Radio Radio Overview Lithium-Ion Li-Ion Battery Side ButtonsModel Frequency Transmit Power Number Antenna Band Battery Features and Charging Options About the Li-Ion BatteryBatteries and Chargers Batteries and ChargersBattery Recycling and Disposal Battery Latchbattery latch Slots Turn OFF the radio Batteries and Chargers Install Remove Power Supply, Adaptors and Drop-in Tray ChargerInstalling Spring Action Belt Clip Battery Life InformationFollowing chart summarizes battery life estimations Charging the Battery Charging with the Drop-in Tray Single Unit ChargerCharging a Stand-Alone Battery Charging a Standard Battery Adjustable bracket Standard High and Ultra High Capacity Charging a High Capacity Battery Drop-in Tray Charger LED Indicators Standard Charger LED IndicatorEstimated Charging Time MUC LED Indicator Adjusting Volume Getting StartedGetting Started Turning Radio ON/OFFReceiving a Call Selecting a ChannelTalking and Monitoring Signal Strength Indicator and Channel Busy Indicators Talk RangeGetting Started Getting Started Radio LED Indicators Radio Status LED IndicationWith Compatible VOX Accessories HANDS-FREE USE/VOXReset To Factory Defaults Hands Free without Accessories iVOXBattery Save Setting VOX/iVOX Sensitivity End of Transmission Tone Roger Beep ToneKeypad Beeps Menu OptionsSetting VOX / iVOX sensitivity IVOGetting StartedImic YES Programming Features Entering Programming ModeProgramming RX Reception Codes CTCSS/DPL Programming FeaturesProgramming RX Reception Frequencies RX BW Programming RX Reception BandwidthProgramming Scramble L Programming Maximum Number of ChannelsMA X CH Programming Call TonesProgramming Microphone Gain Level YES Programming Scan ListProgramming Buttons Editing Channel Alias Name Nuisance Channel Delete Bandwidth Select Time-Out TimerCPS Computer Programming Software Scramble Battery Type SettingCall Tones Programming Features Cloning Radios Cloning with a Multi-Unit Charger MUC Turn on the Target radio and place it Into one of the SUCs What to do if cloning fails Cloning Radios using the CPS Computer Programming Software Troubleshooting TroubleshootingDoes not come on Cannot activate VOX USE and Care USE and CareIf the radio is submerged in water Channel Radios PMR 446 Defaults Frequency and Code ChartsFrequency and Code Charts Ctcss DPL Codes 108 627 115 712 Warranty Warranty InformationWhat is not Covered by the Warranty Motorola LimitedMotorola Limited Warranty Accessories Chargers Page 6871663M05