GE 27957 manual Changing the Battery, Changing the Security Code

Erase message	0 (during message playback)
Skip message	3
Turn off/on answering system	4
Review voice menu options	7

The base LCD shows REMOTE ACCESS ANSWERING CALL.

TIP: You can bypass the outgoing announcement by pressing any numbered key on the touch-tone pad while the announcement is playing. Then, you can enter your security code to access the answering system.

Changing the Security Code

The default security code for accessing the answering system from another location is 1 2 3.

The security code is set through the programming menu. Refer toTelephone Set Up for more information.

Changing the Battery

Make sure the telephone is OFF (not inTALK mode) before you replace battery.

1.Remove the battery compartment cover.

2.Disconnect the battery plug from the jack inside the battery compartment and remove the battery pack from the handset.

3.Insert the new battery pack and reconnect the battery plug to the jack inside the compartment.

4.Put the battery compartment cover back on.

5.Place handset in charge cradle to charge. If you don’t charge the handset battery properly (for 16 hours) when you first set up the phone and/or when you install a new battery pack, the battery’s long-term performance will be compromised.

NOTE: If the battery is not properly installed in the handset, or if the battery pack is not properly connected to the jack inside the battery compartment, “NO BATTERY” shows in the display when you place the handset back in the charge cradle.

39