Mitel 5603 manual LED Error Indications, Pdm

Mitel 5603 Wireless Handset User Guide

Display shows	Probable cause	Action or comment
SERVICE required	Easy replacement procedure not	Send the handset for service.
Invalid IPDI	followed correctly or failure during
	easy replacement procedure.
Note: This display
message is only shown in
English.
Enter PIN code	The handset’s lock is activated.	Enter the required PIN code. If PIN
		code lost enter new via PDM or do
		a factory reset via PDM.
Battery low, charge now	The battery level is low.	Charge or replace the battery.
Phonebook is not	The phonebook does not respond, not	Try again later or if fault persists do
available at the moment.	available at the moment.	a factory reset via admin menu or
		PDM.
Voice mail number not	There is no Voice mail number	Define a Voice mail number via
defined	defined in the handset.	PDM.
Could not encrypt	The parameter "Encryption Required"	1. Disable the "Encryption
connection	is enabled in the handset in	Required" parameter in
	combination with;	handset; and/or,
	1. Unencrypted base station(s);	2. Enable the encryption in the
	and/or,	base station(s); and/or,
	2. Unsupported base station(s).	Note: If base station(s) is used,
		the software version must be 3.1.x
		or later.
		3. Use supported base station(s).
		Ask your supplier.
		Page 2 of 2

LED Error Indications

See also chapter LED Indications during Easy Replacement on page 59.

LED is flashing red, quick flash, (100 ms on, 800 ms off)

1.If a third handset, that is another handset than the "old" (the replaced handset) and "new" (the replacement headset) handset, is inserted into the charger during Easy Replacement, this error indication appears. Change to the correct handset.

2.The charger has found that Easy Replacement does not work. Change back to the "new" handset.

LED is flashing red, long flash (800 ms on, 100 ms off)

Error during Easy Replacement. Both telephones need to be sent for service.

52