Toshiba Strata CTX manual Call Forward Procedures, To change your Pass Code

Advanced Operation

Call Forward

Call Forward Procedures

The following table contains Call Forward Button sequences. You can do a Call Forward function by one, entering the button sequence as described, or two, programming a flexible button to perform the sequence. See “Call Forward Procedure” on page 12 for instructions on programming a flexible button.

Some Call Forward features require a Pass Code entry. Use the following procedure to change your Pass Code.

➤To change your Pass Code

➤Lift the handset, press ￿￿￿￿￿+ ext. no. + old Pass Code (1~15 digits) + ￿￿+ new Pass Code (1~15 digits) + ￿.

➤To use the Call Forward button sequence

➤Follow the instructions in the following table, shown under “Button Sequence.” Some features require additional input, such as:

•Destination – If the destination is an outside number, press ￿￿after entering the destination. The CTX accepts destination numbers of up to 32 digits.

•Timer – This is a two digit entry representing how long (8 to 160 seconds) your telephone should ring before forwarding the call. If you enter one digit, you must press ￿￿after entering the single digit.

•Pass Code – A four-digit code established by system programming to prevent unauthorized changes. The code applies to the station to be forwarded; not to the station entering the code.

Note In the following table, (Tone) means that a confirmation tone will play at that point in the sequence.

Table 1 Call Forward Procedure

Feature		Button Sequence
Call Forward Any Call (Internal and Incoming Line)
All Calls	Lift handset, press	(Tone) + Destination No. + ￿￿(Tone)
Busy	Lift handset, press	(Tone) + Dest. No. + (Tone)
No Answer	Lift handset, press	(Tone) + Dest. No. + ￿￿(Tone) + Timer + ￿
Busy No Answer	Lift handset, press	+ Dest. No. + ￿￿+ Timer + ￿
Cancel	Lift handset, press ￿￿￿￿￿(Tone)

12 Strata CTX Standard Telephone 05/02