Toshiba Standard Telephone manual Call Forward Procedures, To change your Pass Code

Call Forward Advanced Operation

Call Forward Procedures

The following table contains Call Forward Button sequences.You can do a Call Forward function by one, entering the button sequence as described, or two, programming a flexible button to perform the sequence. See “Call Forward Procedure” on page 12 for instructions on programming a flexible button.

Some Call Forward features require a Pass Code entry. Use the following procedure to change your Pass Code.

➤To change your Pass Code

➤ Lift the handset, press

+ ext. no. + old Pass Code (1~15 digits) +

+ new Pass Code (1~15

digits) + .

➤ To use the Call Forward button sequence

➤ Follow the instructions in the following table, shown under “Button Sequence.” Some features

require additional input, such as:

♦

Destination – If the destination is an outside number, press after entering the destination.

The CTX accepts destination numbers of up to 32 digits.

♦ Timer – This is a two digit entry representing how long (8 to 60 seconds) your telephone

should ring before forwarding the call. If you enter one digit, you must press after entering

the single digit.

♦ Pass Code – A four-digit code established by system programming to prevent unauthorised

changes. The code applies to the station to be forwarded; not to the station entering the code.

Note In the following table, (Tone) means that a confirmation tone will play at that point in the

sequence.

#

Table 1

Call Forward Procedure

#670

Feature

Button Sequence

#

Call Forward Any Call

(Internal and Incoming Line)

All Calls

Lift handset, press

(Tone) + Destination No. + (Tone)

Busy

Lift handset, press

(Tone) + Dest. No. +

(Tone)

No Answer

Lift handset, press

(Tone) + Dest. No. +

(Tone) + Timer +

Busy No Answer

Lift handset, press

+ Dest. No. + + Timer +

# #

Cancel

Lift handset, press

(Tone)

12

#60543211

Strata CTX#

Standard Telephone User Guide

October 2002

#

##

#