Additional Extension Settings

Mitel 3000

Getting Started Guide

The following parameters may be also be set on an extension-by-extension basis. Refer to the full “Administrator’s Manual” for detailed programming instructions if required.

25 Hz	This allows the ringing frequency to be changed from 50 to 25 Hz.
	The default setting is 50Hz however some older phone equipment
	may require 25 Hz for ringing. This setting should only be applied if a
	telephone does not ring correctly at 50 Hz.
3.1 kHz Station	Allows an outgoing call to be set for 3.1Khz minimum bandwidth. It is
	advisable to set this for Fax or Modem calls out over ISDN lines
Extension Disconnect	No dial tone is supplied to the extension and it cannot be used. This
	is generally used if an unoccupied office is equipped with a phone
	that will be turned on for use at some future date.
Hot Line	Allows an extension to be set to call a pre-programmed number
	when the extension goes off hook. Typically used for unsupervised
	reception areas or fax machines.
Individual Caller ID	The Administrator can decide which extensions have individual
Lists	Caller ID Lists.
Keypad Confirmation	Allows the keypad tones to be switched on/off on an extension-by-
	extension basis.
Manager/Assistant	Allows specific features to be mapped between a manager and
	assistant for improved functionality.
No Call Logging	Prevents calls to and from this extension being stored in the Station
	Message Detail Recorder (SMDR) log.
External Diversions	This prevents or allows extensions to forward their calls externally. It
	also allows or prevents an extension from using external transfer or
	conference with two lines and an extension.

Open Door Restriction An extension can be restricted from opening the door if a remote door opening system is installed.

Page Protect	Removes an extension from the paging group.
Port Swapping	Allows two extensions to be swapped on the system for
	administration or programming purposes.
Permanent CLIR	Allows a station to be set so that it never sends the CLI number
	when making an outgoing call (CLIR)
Permanent COLR	Allows a station to be set so that it never shows the CLI number
	during a connected incoming call (COLR)
Restrict use of PA	Prevents an extension from accessing the optional PA system if
	connected to the system.