NetComm VoIP WiFi Phone V24W User Guide
Appendix A: Common Problem And Solutions
This appendix provides solutions to problems that may occur during the installation and operation of the V24W IP Phone. Read the description below to solve your problems.
1.When I make a telephone call, the call doesn’t go through; instead, I hear a fast busy signal.
Go through this checklist until your problem is solved:
•Follow these instructions to reboot your cable or DSL modem, IP Phone, and router:
1.Power off your cable or DSL modem by unplugging its power adapter.
2.Power off the router by unplugging its power adapter.
3.Power off the IP Phone by pressing and holding down the Power button for two seconds.
4.Wait 30 seconds, and then power on your cable or DSL modem by plugging its power adapter into an electrical outlet.
5.Wait 30 seconds. Power on the router by plugging its power adapter into an electrical outlet.
6.Wait 10 seconds. Power on the IP Phone by pressing and holding down the Power button for two seconds.
7.Reboot one of your networked computers, and check for an active Internet connection.
8.Pick up the IP Phone and try your call again.
•Set up port forwarding on your router. You must specify that four port ranges be
forwarded to the IP address of the IP Phone. These four port ranges are as follows:
If you have a non- router, refer to its documentation for instructions. If you have a router, then follow these instructions:
1.On one of your networked computers, open your web browser.
2.Access the Router’s
3.A login screen will appear. Leave the User Name field blank. Enter the Router’s password (the default is admin) in the Password field. Then click the OK button.
4.Click the Applications & Gaming tab, and then click the Port Range Forwarding tab.
5.For each port range you must specify, enter a different name in the Application field. Then enter the number or range of external port(s) used by the IP Phone.
6.Select the protocol you will be using, UDP.
7.Enter the IP address of the IP Phone. For example, if the IP Phone’s IP address is 192.168.1.100, you would enter 100 in the field provided.
8.Repeat steps
Application | Start and End | Protocol | IP Address |
Enable Internet Phone 1 | 5060 to 5061 | UDP | IP address of IP Phone |
X Internet Phone 2 | 53 to 53 | UDP | IP address of IP Phone |
X Internet Phone 3 | 69 to 69 | UDP | IP address of IP Phone |
X Internet Phone 4 | 10000 to 20000 | UDP | IP address of IP Phone |
YML873 V24W User Guide - 36