Geemarc 100VM manual Dialling Stored Number, Voice Meter Function, Hold Function

USING THE PHONE

- Press one of the direct memory buttons, M1, M2, CS.

Or press M and any button 0 to 9 on the key pad under which you wish to store the telephone number in indirect memory.

-Replace the handset.

Note : Numbers will be lost if you disconnect your phone. Entering a new number in memory will automatically erase the previous number.

9 - Dialling Stored Number

-Lift the handset and await the dial tone.

-Press appropriate direct memory button M1, M2, or CS. The stored number will be dialled out automatically.

Or press the M button followed by the keypad 0 to 9 button under which the desired number is stored. The stored number will be dialled out automatically.

To register your stored phones numbers, use the index located on the base.

10 - Voice Meter Function

Push switch to adjust voice level meter ON and OFF .

On mode:

When unit is off-hook, the voice meter LEDs inside the memory card cover will indicate the outgoing voice level on telephone line.

Off mode:

When unit is off-hook, the voice meter is turned off.

11 - Hold Function

The Hold function is designed to stop conversation temporarily.

Hold On:

In off-hook state, to press "HOLD" key on the keyboard, the Hold function is enabled and all speech meter LEDs are turned on.

7