Oregon Scientific OS6976 user manual Speakerphone Operation

RINGER

The ringer must be ON for the handset to ring during incoming calls. Refer to the Ringer Setup section for instructions on turning on the ringer.

VOLUME

While talking, press the volume buttons (left and right arrows) to adjust the listening level of the handset's earpiece. There are four volume levels. Press the right arrow (+) button to increase the volume level, and press the left arrow (-) button to decrease. VOL 1 is the lowest level and VOL 4 is the loudest.

CALL TIMER

While you are talking on the phone, the total talk time is displayed on the bottom line of the display.

SPEAKERPHONE OPERATION

SPEAKERPHONE LOCATION

For best speakerphone performance, avoid the following:

•Areas with high background noise. (The microphone might pick up these sounds and prevent the speakerphone from going into the receiving mode when you finish talking.)

•Surfaces affected by vibration.

•Recessed areas such as in a corner, in a cupboard, or next to a cabinet, which can generate an echo effect.

SPEAKERPHONE GUIDELINES

•The speakerphone works similar to a two-way radio, you can only listen or talk at one time.

•Stay reasonably close to the phone so that you can be clearly heard by the person to whom you are talking.

•Press the speaker button to turn on the speakerphone.

•Press the CID VOL(+) or CID VOL(-) arrow button on the Spacemaker® to adjust the

speakerphone listening level. You will hear a tone when you reach the minimum or maximum volume level.

REGISTRATION

The Spacemaker® is pre-registered to the wall base unit.

If your Spacemaker® is properly connected, but you cannot hear a dial tone when pressing the SPEAKER button, it may not be properly registered. Then, follow these steps to re-register the Spacemaker® to the wall base unit:

1.Move the Spacemaker® close to the wall base unit or vice versa.

2.Make sure both the handset and the Charge speakerphone are OFF (not in TALK mode).

22

EN

os6976-en1.p65 25 5/6/2005, 10:32 AM