Oricom eco5200 Series manual Getting Started, Installation and Charger, Tip

Page 6

GETTING STARTED

Getting Started

Installation and Charger

1. Connect the mains adaptor (supplied) to the socket on the back of the base unit and to the wall mains supply.

2. Connect the telephone cord to the phone socket on the back of the base unit and into the wall phone socket.

Important: DO YOU HAVE BOADBAND/ADSL?

If you do, you must connect an in line ﬁlter (not supplied) between the telephone socket and your eco5200 base to ensure that your broadband and eco5200 will work properly. If you do not install the ﬁlter you will experience interference on the eco5200 and your Broadband may suffer dropouts. Please refer to the user guide of the in line ﬁlter for installation.

Note: In Australia some phone wall sockets are the old non modular style. If you have this type of wall socket you will need to purchase a “modular converter plug” (not

supplied). These can be obtained from electronic stores.

3. Insert 2 rechargeable Ni-MH AAA batteries (included), ob- serving the correct polarity, into the battery compartment on

the handset. Slide the battery door ﬁ rmly into place.

4. Place the handset on the charging cradle and charge the bat- teries for a full 15 hours before using it for the ﬁ rst time.

Note: It may take some time for the cordless handset to

power up, and it may get warm during initial charge. This is normal.

Tip!

It is good practice to put the cordless handset on the charging cradle when it is not in use to ensure that the handset is always fully charged.

2

Image 6

Contents User Guide Keep this user guide for future referenceContents Caller ID Operation …………………………………………………………… Answering Machine Operation ……………………………………………… Page Important do YOU have BOADBAND/ADSL? Installation and ChargerGetting Started TipGetting Started Pack contents Purchasing additional handsetsYour cordless handset Understanding the cordless handset display Your eco5200 base unit Bottom GS Answering Machine Rings Code Answering Machine PINBasic Operation During standbyAnswering an incoming call Normal dialling Mute featureMaking an external call Pre-diallingRecall feature Call waiting Australia onlyTake two different calls at the same time Pause feature when using on a Pabx Handsfree modeRecall function when connected to a Pabx Speaker volume control Volume adjustment with base unitVolume adjustment with handset Ringer volume controlCaller ID Operation Review Caller ID recordsStore a CID number Delete one or all CID records Delete all viewed CID recordsLNR Function Last Number Redial Redial the last numberStore the last number dialled Delete last number dialledPhonebook Add new recordsReview / Edit / Dial stored Phonebook records Delete one record JohnCordless Handset Operation Handset ringer adjustmentHandset ringer volume Handset ringer melodyMulti-handset Operation Intercom functionCall transfer between cordless handsets Cordless handset keypad lock RegistrationRegister new handsets on the eco5200 base Language setting Remove handsetsReset Handset nameDay/Time setting Answering Machine OperationAnswering machine On / Off Answering machine Ring delay Setting Answering machine PIN number SettingOGM setting OGM1 Announcement One modeOGM2 Announcement Two mode OGM Outgoing MessagesPlay OGM OGM play to lineICM Incoming Messages Record ICMPlay ICM Record memo MemoDelete messages Play memoMemory full Delete all messagesPage Call screening Cordless handset detectionRemote operation keys Toll saver Remote turn-onCustomer Support Troubleshooting AppendixAlternatively please contact Customer Service on 1300 889 Product Speciﬁcations Phone Oricom eco5200 SpeciﬁcationsWarranty Information Warranty AustraliaExclusion and limitation of liability REN RN for New Zealand Caller IDCustomer Support