Answering System Operation
±"016'"±"
±Recording/Deleting an Outgoing Message Outgoing messages must be between 2 and 30 seconds long.
±ýSetting the System to
Answer Calls
When the system’s message memory is full, <B appears and the system announces “No remaining time” when you try to operate it.
To switch between your outgoing message and the system’s prerecorded message, press OGM. The current message plays. While the message is playing, press OGM again.
4'%14&+0)1&'.'6+0)"#0"
176)1+0)"/'55#)'
1.Hold down OGM. The system announces
“Record greeting,” followed by a beep. #ý# flashes.±ý
2.Speak your message.
3.When you finish your message, press OGM or PLAY/STOP. The system beeps and plays back your message.
To delete your outgoing message and use the system’s prerecorded messages, press OGM, then press DELETE when your message plays. The system announces “Greeting has been deleted.”
5'66+0)"6*'"5;56'/"61"#059'4" %#..5
Press ANSWER.
If the system is set to record a caller’s message (see “Setting the Record Time” on Page 28), it plays the outgoing message and the number of recorded messages appear.
If the system is set to 7ddekdY[c[djýEdbo, it plays the outgoing message, and 7 appears.
To set the system to not answer calls, press ANSWER again. The system announces “Answer off” and the message counter turns off. ±ý
30